Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
1. A flow of 1 kg/s of air at 300 K is mixed with a flow of 2 kg/s air at 1500 K in an insulated pipe junction at a pressure of 100 kPa. Find the exit temperature and the exergy destruction.
2. The condenser in a power plant cools 10 kg/s water at 10 kPa, quality 90%, so it comes out as saturated liquid at 10 kPa. The cooling is done by ocean water coming in at ambient 15?C and returned to the ocean at 20?C. Find the transfer out of the water and the transfer into the ocean water of both energy and exergy (four terms).
A MH at an intersection has an inflow from three 8-inch PVC (n = 0.01) sanitary sewer pipes laid at minimum slope converging at an intersection and one pipe taking the flow from those three further downstream.
Determine the load to be imposed on foundation - Using Meyerhof's method and using Terzaghi's method by considering General Shear Failure mode.
Motor D and pulley G weigh W and w respectively. When the motor is turned off, the belt tension is T. The force P acts on member ACF, not on pin F. Determine the tension in the cable CB.
Plan 2 has a $40/month access fee, unlimited nights and weekends, 750 anytime minutes plus $0.29/minute for minutes over 750, text messages cost $0.05 each, and roaming cost $0.39/minute whenever she leaves the state.
The rigid bar abcd is supported by a pin at B and restrained by identical steel bars at C and D, each of area 250mm 2 . if the temperature is increased by 8 0 C, find out the force P that will cause the bar at c to be stress-free.
A new section of richmod highway is being designed as a six-lane facility (three in each direction) with a two-way, left-turn lane. Determine the peak hour LOS. Assumed base free flow speed = 55mi/h
As a design engineer you are responsible for all the drawing documentation from your organisation. What are the key aspects of the drawing you need to check before sending it to the construction division
Link BC is 6 mm thick, has a width w= 25 mm, and is made of a steel with a 480 MPa ultimate strength in tension. What is the safety factor used if the structure was designed to support a 16 kN load P
Ammonia is a gas whose smell we detect in manure, cleaning products, and other things. The concentration of this noxious gas can be controlled by regulating the pH of the water because only the non-protonated form, NH3, is volatile.
If the rocket's decent parachute does not deploy and the rocket lands 340 ft from A, determine the angle (alpha) that vo forms with the vertical, the maximum height h reached by the rocket, and the duration of the flight.
WHat volume of sludge must they dispose of each year if their sand drying beds yield a solids concentration of 35%
Assuming that the velcity of a 185 lb athlete just before landing is 30 ft/s at an angle of 35 degrees with the horizontal and that the athlete comes to a complete stop in .22 seconds after landing,
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd