### Find the diameter of the tube to accomplish this

Assignment Help Civil Engineering
##### Reference no: EM13542347

1.A smooth prolate spheroid has its major axis make an angle alpha with the free stream. The major axis has a length 2a and the minor axis has length 2b. The flow is incompressible, but friction and inertia influences the flow pattern. Use dimensional analysis.

Find the dimension parameters that affect the drag coefficient.

2.It is desired to transmit 300mm^3/s of gasoline at 20 degree Celsius through a 650mm long horizontal tube with a head loss of 500mm Find the diameter of the tube to accomplish this.

### Write a Review

#### Determine what is the maximum average running speed

The maximum speed of trains for urban rail transit is 60 mph and maximum acceleration/deceleration rates allowed for standing passengers are 5 feet/sec2. Part A) If the station spacing is determined at 1000 ft, what is the maximum average running s..

#### Determine consequent compressive stress in the curtain wall

Because of the insulation between them, the sun heats up the wall panel 120 degrees F but the column to 80 degrees F. Determine the consequent compressive stress in the curtain wall.

#### Determine the ntu values for each sampling port depth

The packed tower was 30 cm in diameter with sampling ports located at packing depths of 0,2,4,6,8,10, and 12 meters. The loading of water to the tower was 0.039 m^3/(m^2/s), and the temperature of groundwater was 10 degrees celcius.

#### What is the angle theta required for equilibrium

what is the maximum weight of the crate that the system can support? What is the angle theta required for equilibrium?

#### Estimate the weight of concrete in four-lane highway segment

Estimate the weight of concrete in a four-lane highway segment that begins as a 3% grade climb from 1000 feet altitude to 4000 feet and then a 6% downgrade to 2500 feet

#### Determine the instantaneous center of rotation of the spool

Knowing that end B of the tape is pulled downward witha velocity of 300 mm/s and that at the instant of the total thickness of the tape on the spool is 20 mm, determine (a) the instantaneous center of rotation of the spool,

#### Explain which is 625 feet long connects two bodies of water

A pump is to be used to draw seawater from the bay at an elevation of 0 to a reservoir at a desalination plant that has a water surface elevation of 255 feet. A 12-inch diameter DIP pipe (CHW = 120) which is 625 feet long connects the two bodies ..

#### Determine the required minimum compression in the spring

If = 300 N , determine the required minimum compression in the spring so that the wedge will not move to the right. Neglect the weight of A and B. The coefficient of static friction for all contacting surfaces is .2 Neglect friction at the rollers..

#### Create a primary function

create a primary function that uses a function handle with a nested function to compute the ninimum of the function 20x^2-200x+12 over the range 0

#### Find the absolute-gage and vacuum pressure heads

A glass jar is heated in an oven and sealed when the air pressure is 103 kPa and the temperature is 105 C. Find the absolute, gage, and vacuum pressures in the jar when it cools to 20 C.

#### Consider maximum positive and negative bending moments even

Plot the moment envelope curves(positive and negative). (NOTE: You only need to consider maximum positive and negative bending moments even though for a true envelope curve you would have to consider all points between the supports.)

#### Discuss the limitations of the monitoring approach

A passive dosimeter is to be designed for use in obtaining monthly average concentrations of atrazine in a stretch of river. Typical concentrations range from 10 to 50 g/L. Atrazine, a herbicide commonly found in runoff from agricultural lands.