Find how much existing highway must be reconstructed

Assignment Help Civil Engineering
Reference no: EM13307008

Due to a crash at a railroad crossing, an overpass is to be constructed on an existing level highway. the existing highway has a design speed of 50 mi/h. The overpass structure is to be level, centered 26 feet above the railroad, and 180 feet long. How much existing highway (in feet) must be reconstructed to provide appropriate vertical alignment?

Reference no: EM13307008

Questions Cloud

Find the acceleration of a forklift of mass : Find the acceleration of a forklift of mass 1400 kg pushed by a force of 2100 N that is opposed by a frictional force of 425 N.
Find the deepest value in a binary tree in c++ : How do you find the deepest value in a binary tree in C++?
Calculate the stress in a rebar subjected to tensile bar : Calculate the stress in a No. 7 rebar subjected to a tensile load of 10,600 lb (in ksi).
Calculate the energy needed to accelerate a spaceship : Calculate the energy needed to accelerate a spaceship with a mass m = 25 × 103 kg toa speed of 0.40c. Compare this number with the approximate annual energy usage ofEarth, 1021 J
Find how much existing highway must be reconstructed : The overpass structure is to be level, centered 26 feet above the railroad, and 180 feet long. How much existing highway (in feet) must be reconstructed to provide appropriate vertical alignment
The crate is sliding down the ramp : 1)A crate of potatoes of mass 19.0 kg is on a ramp with angle of incline 30° to the horizontal. The coefficients of friction are μs = 0.82 and μk = 0.29. Find the frictional force (magnitude and direction) on the crate if the crate is sliding d..
Find how much time passes before the ice starts to melt : An open container holds ice of mass 0.595kg at a temperature of -13.5 celcius . The mass of the container can be ignored. How much time passes before the ice starts to melt
What is total delay for cycle for the saturation flow rate : A signal approach has 20 seconds of displayed green, 4 seconds of yellow, and 3 seconds of all red (assume typical start-up, lost time, and clearance time). The cycle length is 60 seconds.
The crate is sliding up the ramp : A crate of potatoes of mass 8.0 kg is on a ramp with angle of incline 30° to the horizontal. The coefficients of friction are μs = 0.72 and μk = 0.43. Find the frictional force (magnitude and direction) on the crate if the crate is sliding up t..

Reviews

Write a Review

Civil Engineering Questions & Answers

  At what angle did the player have to shoot the cue ball

(a) At what angle did the player have to shoot the cue ball so that the eight ball entered the pocket at C? (b) In what direction did the cue ball move after the collision? (c) What percentage of its kinetic energy did the cue ball impart to the e..

  Determine the magnitude and direction of the resultant

Part of the roof of a sports stadium is to be supported by the cables AB and AC. The forces the cables exert on the pylon A to which they are attached are represented by the vectors FAB and FAC.

  Calculate the specific weight of the material

Your engineering consulting firm has been asked to determine the specific weight of an unknown material. You decide to use the concept of buoyancy to figure this out. So you weigh the material in both air and water.

  Calculate the precentage of carbon hydrogen and oxygen

Calculate the precentage of carbon hydrogen and oxygen in ethanoic acid.

  Determine the force required to lift the block of stone

Determine the force required to lift the block of stone that weighs 200 lb. The rollers are frictionless and the static coefficient between all other surfaces is 0.3. Neglect the size and weight of the wedges.

  Find the maximum area that the rancher can enclose

A rancher has 1200 ft of fencing to enclose a double paddock with two rectangular regions of equal areas. find the maximum area that the rancher can enclose.

  How to determine the force that must be applied at a

The uniform load has a mass of 450 and is lifted using a uniform 35- strongback beam and four ropes. Determine the Tension in the ropes Determine the force that must be applied at A.

  Determine what diameter pipe would be recommend

A circular concrete pipe (n = 0.012) carries a discharge of 450 cfs with a slope of 0.008 and is designed to run no more than 60% full (by depth). What diameter pipe would you recommend

  Determine the minimum height on the wall from hose

Determine the minimum height on the wall to which the firefighter can project water from the hose, so that the water strikes the wall horizontally. The speed of the water at the nozzle is Vc=48ft/s.

  Determine what is the final temp and the final mass of air

an insulated tank is evacuated. Air from the atmosphere at 12 psia and 70 degrees farenheight is allowed to flow into the 100 cubic foot tank. What is the final temp and the final mass of air in the tank just after flow ceases.

  Describe does the sample meet the niosh standard

The National Institute for Occupational Safety and Health (NIOSH) sets standards for CCl4 in air at 12.6 mg/m^3 of air (a time average over 40 hr). The CCl4 found in a sample is 4800 ppb. Does the sample meet the NIOSH standard

  Determine the required value for m

A 1 meter diameter cylindrical mass, M, is connected to a 2 meter wide rectangular gate. The gate is to open when the water level, h, drops below 2.5 meters. Determine the required value for M. Neglect friction at the gate hinge and pulley.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd