Explain what volume will a sample of hydrogen occupy

Assignment Help Chemistry
Reference no: EM13502214

What volume will a sample of hydrogen occupy at 28.0 degrees celsius if the gas occupies a volume of 22.3 dm3 at a temperature of 0.0 degrees Celsius? assume that the pressure remains constant

Reference no: EM13502214

Questions Cloud

Explain the density of the water was 1.00g/ml : If you drink a glass of water, what mass, in grams, of this "unknown" substance will you ingest. The volume of your drink was 250 mL and the density of the water was 1.00g/mL.
Explain how much heat is required to warm of water : How much heat is required to warm 1.50 L of water from 30.0 C to 100.0 C? (Assume a density of 1.0g/mL for the water.)
Do you see the utilization of computers : Do you see the utilization of computers and the subsequent increase in gathering of information as a primarily good or bad development?Defend your position by appealing to Utilitarian or Kantian arguments.
Explain the same temperature as the original mixture : When the sample burned, the products were CO2 gas and H2O vapor. The CO2 was collected and its pressure found to be 25.2kPa in the same volume and at the same temperature as the original mixture. What % of original mixture was methane
Explain what volume will a sample of hydrogen occupy : What volume will a sample of hydrogen occupy at 28.0 degrees celsius if the gas occupies a volume of 22.3 dm3 at a temperature of 0.0 degrees Celsius. assume that the pressure remains constant
Explain the final state of the drink assuming instant : What is the final state of the drink assuming instant heat transfer between the components (show how you arrived to this conclusion)
Effect on the current ratio : Firm capitalizes a lease instead of treating the lease as an operating lease, the effect on the current ratio and the debt-to-equity ratio
Explain the catalytic efficiency of the enzyme under : If the Km of carbonic anhydrase for the above reaction is 1.8 mM, what is the catalytic efficiency of this enzyme under these conditions? The units are s-1M-1.
Find the recoil velocity of the car : A military gun is mounted on a railroad car (m = 1419 kg) as shown in the figure below There is no frictional force on the car, Find the recoil velocity of the car

Reviews

Write a Review

Chemistry Questions & Answers

  Explain the molar mass determination

two mwthods were described for determining the volume of the flask used for the molar mass determination.

  Explain the mole fraction of methane in the mixture

A gaseous fuel mixture stored at 745mmHg and 298 K contains only methane CH4 and propane C3H8. When 11.5L of this fuel mixture is burned, it produces 774kJ of heat. What is the mole fraction of methane in the mixture

  Given 150g of nh3 reacts with 275g of o2 which is the

4nh3 5o2 yields 4no 6h2ogiven 1.50g of nh3 reacts with 2.75g of o2 which is the limiting reactant? how many grams of

  Explain how many moles of h3o+ must be added to solution

How many moles of H3O+ must be added to one liter of a solution to adjust the pH from 7.90 to 6.16? Use E notation and 3 significant figures.

  What is the rate of change of the total pressure of vessel

The reaction 2NO(g) + Cl2 (g) --> 2NOCl(g) is carried out in a closed vessel. If the partial pressure of {NO} is decreasing at the rate of 27 torr/min, what is the rate of change of the total pressure of the vessel?

  What is the rate constant for this reaction

The reactant concentration in a zero-order reaction was 7.00×10-2 after 105 and 1.50×10-2 after 350 . What is the rate constant for this reaction.

  What proportion of the molecules have enough speed to

calculate the escape velocity the minimum initial velocity that will take an object to infinity from the surface of a

  Compute the ph that added hcl

the equivalence point occured at 4.67 mL of HCl. Calculate the pH at 0.00 mL of added HCl and at 2.00 mL of added HCL

  A solid block of exactky 1000 cm 3 has a mass of 1536g

a solid block of exactky 100.0 cm 3 has a mass of 153.6g. determine its density. will the block sink or float on

  Explain the 1-bromobutane is converted to butene

What is the maximum volume (at STP) of butene gas that could be obtained from the reaction of 1-bromobutane with KOH if all of the 1-bromobutane is converted to butene

  Calculate the initial and the final ph

For 220.0 mL of a buffer solution that is 0.205 M HCHO2 and 0.295 M KCHO2, calculate the initial and the final pH after adding 0.010 mol of NaOH.

  How many moles of no2 gas can be produced from 455 g of o2

how many moles of no2 gas can be produced from 45.5 g of o2 gas in the following reaction? show your work in the answer

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd