User Account

All Pages

Explain what is the ratio of acetate to acetic acid

Assignment Help Chemistry
Reference no: EM13268623

A solution is prepared by adding 0.1M acetic acid and 0.01 M ethylamine to water and adjusting the pH to 7.4. What is the ratio of acetate to acetic acid? WHat is the ratio of ethylamine to ethylammonium ion?

Reference no: EM13268623

Questions Cloud

Determine the coefficient of variation for rate of return : Assuming that Phoenix is not expected to pay any dividends during the coming year, determine the coefficient of variation for the rate of return on Phoenix stock.
What is the density of the rock : You are working on the analysis of rocks brought back from the Moon, What is the density of the rock
Find the power delivered to the motor bt two batteries : Two batteries with 1.8 voltage and 10.5 Ohm internal resistance each are connected in series. This battery pack is used to boot a small electric motor with 275 Ohm resistance. Find the power delivered to the motor.
Calculate the value of the securities to decide : You must calculate the value of the securities to decide whether they are a good investment. What is their present value to you? Round your answer to the nearest cent.
Explain what is the ratio of acetate to acetic acid : A solution is prepared by adding 0.1M acetic acid and 0.01 M ethylamine to water and adjusting the pH to 7.4. What is the ratio of acetate to acetic acid. WHat is the ratio of ethylamine to ethylammonium ion
What is the minimum uncertainty in this particles energy : The muon is an unstable particle, with a mean lifetime of 2.5x10^-10 seconds. What is the minimum uncertainty in this particle's energy
At what load resistance is maximum power delivered to load : A battery is limited in the amount of current that it can supply to a load. When disconnected and fully charged, the voltage across the battery terminals is measured to be 13.8 V. When connected to a load that dissipates 18 W of power
How much additional equity financing required for next year : If all assets, short-term liabilities, and costs vary directly with sales, how much additional equity financing is required for next year?
What is the possible range of inputs for subtraction : Use a 74LS283N Adder chip and a 74LS86N XOR chip. Simulate the circuit in Multisim and test enough input combinations that you are sure the circuit is working properly. Make sure you test in all theranges of numbers that are possible.

Reviews

Write a Review

Chemistry Questions & Answers

  Explain potassium iodide and lead ii chloride

What is the balanced equation for a reaction between potassium iodide and lead II chloride

  What are the boiling and freezing points of the solution

Find molarity, molality, percentage composition, boiling and freezing point of a solution - What are the boiling and freezing points of the solution?

  Explain methanol can be produced by the reaction

Methanol can be produced by the reaction shown below with the following thermodynamic data given at 25 degree Celcius.

  What is the thickness of the resulting sio2 wafer

A 100 mm diameter silicon wafer is oxidized completely. What is the thickness of the resulting SiO2 wafer? The molecular weight of Si is 28 g/mol and of SiO2 is 60 g/mol.

  What will the temperature be

If you drop 25 g warm nails initial temp 65.4 into coffee cup calorimeter that contains 100.0 g water at 20 degrees Celsius, what will the temperature be.

  How much does the ph change

if 0.200mole of NaOH is added to 1 liter of solution that is 0.100M in aqueous ammonia and 0.200M in ammonium chloride how much does the Ph change.

  Explain the flask was then shaken until the solution

The flask was then shaken until the solution was uniform. A 45.0 \rm mL sample of this glucose solution was diluted to 0.500 \rm L. How many grams of glucose are in 100. \rm mL of the final solution

  What is its volume at 760 torr

The volume of a gas sample is 200L at 740 torr. what is its volume at 760 torr? Assume that the Temperature remains constant

  Define why do solutions of iodide ion in water appear yellow

Why do solutions of iodide ion in water appear yellow when I- is oxidized to I2 by a suitable oxidizing agent, while solutions of I- in CCl4 or CHCl2 appear violet when the same oxidationis done?

  State 1erlenmeyer flask by blowing out the sample

a student carried out the experiment but did not follow the directions exacly as written. What effect would the following actions have on the experiment ?

  Calculate the amount of heat liberated

Calculate the amount of heat liberated (in kJ) from 355 g of mercury when it cools from 76.0°C to 13.0°C.

  Define the temprature of the bomb and water increase

calorimeter in which the temprature of the bomb and water increase from 19.5 to 22.83 C? the bomb has a heat capicity of 650 J/K; the caloriemeter contains 320g of water.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

Submit Assignment

Academics

Major Subjects

Majors

Get In Touch

whatsapp: +1-415-670-9521

Phone: +1-415-670-9521

Email: [email protected]

TERMS & POLICIES

HELP & SUPPORT

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd