Explain the presence of the other elements and compounds

Assignment Help Chemistry

Reference no: EM13294871

As a laboratory technician, you are presented with an aqueous sample that was collected from highway runoff during a rain storm. You are to quantitatively analyze for Pb, Zn and Cu in the aqueous sample using flame AAS. As you can imagine, there will be many other elements and compounds present in the solution. How would you best determine the concentration of the analytes in the presence of the other elements and compounds?

Reference no: EM13294871

Questions Cloud

Evaluate the time constan : In an RC series circuit, epsilon= 17.0 V, R = 1.10 MOhm, and C = 1.80 µF. Calculate the time constant.

Explain bottom edge and immersed the plate depth of solvent : Inexperienced workers commonly make mistakes in TLC experiments. Give the result in the following case: * You spotted 1/2 cm from the bottom edge and immersed the plate in 1 cm depth of solvent.

What is the length of the second hand : radial acceleration of the tip of the second hand of a clock is 0.0021 m/s^2 what is the length of the second hand

What would be the minimum samplingrate for playback signal : An electrical signal with the spectrum extending from 10Hz to600Hz is recorded on a tape recoorder at 10cm per second. It isplayed back at 60cm per minute. What would be the minimum samplingrate for the playback signal

Explain the presence of the other elements and compounds : As you can imagine, there will be many other elements and compounds present in the solution. How would you best determine the concentration of the analytes in the presence of the other elements and compounds

Estimate additional time required for the voltage to drop : A capacitor is charged to 100 V and is then disconnected. Leakage reduces its voltage to 35 V in 45 minutes. Estimate the additional time required for the voltage to drop to 8 V. The leakage is represented by a resistance in parallel with the c..

Key issues involved with the correctional staff : Provide an introduction to your position paper with a clear thesis statement that provides an overview of the paper and analyze three (3) key issues involved with the correctional staff.

Determine how many turns of wire are needed : The resistance of a very fine aluminum wire with a 17?m x 17?m square cross section is 1200 ? . A 1200 ? resistor is made by wrapping this wire in a spiral around a 3.9-mm-diameter glass core

Calculate the coil resistance : Two scales on a voltmeter measure voltages up to 20.0 V and 28.0 V, respectively. Determine the coil resistance

User Account

All Pages