Estimate additional time required for the voltage to drop

Assignment Help Electrical Engineering
Reference no: EM13294870

A capacitor is charged to 100 V and is then disconnected. Leakage reduces its voltage to 35 V in 45 minutes. Estimate the additional time required for the voltage to drop to 8 V. The leakage is represented by a resistance in parallel with the capacitance.

Reference no: EM13294870

Questions Cloud

Explain bottom edge and immersed the plate depth of solvent : Inexperienced workers commonly make mistakes in TLC experiments. Give the result in the following case: * You spotted 1/2 cm from the bottom edge and immersed the plate in 1 cm depth of solvent.
What is the length of the second hand : radial acceleration of the tip of the second hand of a clock is 0.0021 m/s^2 what is the length of the second hand
What would be the minimum samplingrate for playback signal : An electrical signal with the spectrum extending from 10Hz to600Hz is recorded on a tape recoorder at 10cm per second. It isplayed back at 60cm per minute. What would be the minimum samplingrate for the playback signal
Explain the presence of the other elements and compounds : As you can imagine, there will be many other elements and compounds present in the solution. How would you best determine the concentration of the analytes in the presence of the other elements and compounds
Estimate additional time required for the voltage to drop : A capacitor is charged to 100 V and is then disconnected. Leakage reduces its voltage to 35 V in 45 minutes. Estimate the additional time required for the voltage to drop to 8 V. The leakage is represented by a resistance in parallel with the c..
Key issues involved with the correctional staff : Provide an introduction to your position paper with a clear thesis statement that provides an overview of the paper and analyze three (3) key issues involved with the correctional staff.
Determine how many turns of wire are needed : The resistance of a very fine aluminum wire with a 17?m x 17?m square cross section is 1200 ? . A 1200 ? resistor is made by wrapping this wire in a spiral around a 3.9-mm-diameter glass core
Calculate the coil resistance : Two scales on a voltmeter measure voltages up to 20.0 V and 28.0 V, respectively. Determine the coil resistance
What is the speed at which the satellite travels : A satellite is in a circular orbit about the earth (ME = 5.98 1024 kg). What is the speed at which the satellite travels

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Determine what is the net electric field at location

A small object with charge Q1=6nC is located at the origin. A second small object with charge Q2=-5nC is located at m. What is the net electric field at location A m due to Q1 and Q2

  What is the quantization signal to noise ratio snrq

What is the quantization signal to noise ratio SNRQ at the receiver output? e. If the SNRQ were to be raised to 96 dB, how many bits would the ADC and DAC need? What would be the bit rate on the serial link?

  Determine what is the terminating load impedance

Use Smith Chart: A 100 Ohm air-coaxial transmission line is measured to have an input impedance of 100 + j100 Ohms. If the system is operated at 100 MHz and is one meter long, what is the terminating load impedance

  Calculate the rotor power factor angle of the motor

In a 60-HZ, 208 V (line-line, rms), 5-kW motor, R'r = 0.45Ω and X'tr = 0.83Ω. The rated torque is developed at the slip s = 0.04. Assuming that the motor is supplied with rated voltages and is delivering the rated torque,

  What value of k makes the system marginally stable

The characteristic equation ofthe system is q(s) = s^5+13s^4+33S^3+32s^2+20s+k^2 where k>0. a). Find the range of values of k for which the system is stable using the Routh-Hurwitz table. b) What value of k makes the system marginally stable

  What is the resonance frequency of the patch antenna

A rectangular patch has length 13 cm and width 0.8*13 cm and is supported by a dielectric substrate with relative permittivity 4. What is (approximately) the resonance frequency (in GHz) of the patch antenna

  Write a program that reads a file containing only integer

Write a program that reads a file containing only integer, but some of the integers have embedded commas, as in 145,020. The program should copy the information to a new file, removing any commas from the information.

  Determine the transmitter power from a transmitting antenna

The power density 50km from a transmitting antenna is 0.5 uW/m^2. If the frequency is 2 GHz and the antenna gain is 30 dB, determine the transmitter power.

  What is the attractive force on a charge q1 of 1µc

the electric field srength E due to an infinite line of chargeis given by E = λ/(2πrεo), where λ is the charge per unit length and r is the radial distance from the wire. a, show that this formular for E still has the units of N/C.

  Design an integral controller

Improve the controller designed in part by introducing a mechanism for the disturbance compensation at the plant input. Illustrate advantage of the improved controller by applying the fast varying piecewise constant reference input vector and sinu..

  What is the equivalent continuous flow of power in megawatts

If the U.S. consumes 10 Quads each year by burning gasoline for automobiles, and if this energy usage is spread evenly across 8760 hours in a year, what is the equivalent continuous flow of power in Megawatts (MW)

  Determine the capacitance of the two-wire line

Capacitance can be altered by bringing the two wire line close to ground. (a) Apply the method of images to determine the Capacitance of the two-wire line shown in the figure, where the lower wire is suspended a distance from the PEC ground.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd