Explain the difference in ph units between the initial ph

Reference no: EM13270261

What is the difference (in pH units) between the initial pH of a 0.20 M NH3 / 0.20 M NH4Cl buffer to the pH of the buffer after the addition of 10.0 mL of 0.10 M HCl to 65.0 mL of the buffer?

A. there is no measurable difference between final and initial pH - that is why it is called a buffer
B. final pH is 0.16 pH units higher than original pH
C. final pH is 0.16 pH units lower than original pH
D. final pH is 0.07 pH units lower than original pH
E. final pH is 0.07 pH units higher than original pH

Reference no: EM13270261

Questions Cloud

What is the bank cost of preferred stock : Sixth Fourth Bank has an issue of preferred stock with a $6.40 stated dividend that just sold for $126 per share.

The constant potential not depend on the spatial coordinate : Consider an electron moving from left to right (toward positive x) in a constant potential of V = 2.0 eV with total energy, E = 5.0 eV. Let the electron be described as a free particle such that the constant potential DOES NOT depend on the spatia..

Write a brief summary of your assessment findings : Write a brief summary of your assessment findings and what significant discoveries did you make about the individual you chose to assess?

How will individual health insurance change in 2014 : How will individual health insurance change in 2014 now that the Supreme Court decision deemed the 2010 health-care-reform law as constitutional?

Explain the difference in ph units between the initial ph : What is the difference (in pH units) between the initial pH of a 0.20 M NH3 / 0.20 M NH4Cl buffer to the pH of the buffer after the addition of 10.0 mL of 0.10 M HCl to 65.0 mL of the buffer

Find the output voltage and total impedance : There is a 3 ohm resistor and j4 ohm inductor in series with each other. There is a 4 ohm resistor, a -j13 ohm capacitor, and a 10 ohm resistor in series with each other.These two series circuits are in parallell with each other.

State the temperature of the material is shown as a function : An experiment is performed on an unknown material and produces the following heat curve. The temperature of the material is shown as a function of heat added. If the sample of material has a mass of m = 9.80 g, calculate the specific heat when thi..

Where is the first source located : There are two coherent microwave sources in the x-y plane. These sources are emitting in phase at a wavelength of ? = 1.00 cm. where is the first source located on the y axis

Determine fourier transform of and plot magnitude function : Consider the signal x(t)=e^-at where a is a positive number. Determine the Fourier Transform of and plot both the magnitude and the phase angle as a function of the frequency.

User Account

All Pages