Explain how these effects were initiated

Assignment Help Civil Engineering
Reference no: EM13536833

1.The great lakes have experienced anthropogenic effects over the last decades.

(a)Describe two effects on the great lakes that have been observed in the last 50 years?

(b) explain how these effects were initiated?

(c) comment on how or if these effects can be mediated or resolved?

2.Is it possible (in this part of the world) for the sun to ever shine directly upon the OUTSIDE of a NORTH-facing wall of a home or other building? If so when?

Reference no: EM13536833

Questions Cloud

When a net amount of work is done on a closed : When a net amount of work is done on a closed system undergoing an INTERNALLY REVERSIBLE process, a net heat transfer of energy from the system also occurs.
What length of time in the model corresponds to one day : A 1:2000 scale tidal model is operated to satisfy Froude’s law. A velocity of 0.02 ft/s is observed in the model. What is the velocity at the corresponding point in the prototype? What length of time in the model corresponds to one day in the prototy..
Determine the rotation of the gear at e : The two shafts are made of A-36 steel. Each has a diameter of 25 mm and they are connected using the gears fixed to their ends. Their other ends are attached to fixed supports at A and B
What is the probability of a water shortage in this city : During the next month, the amount of water available for a city is lognormally distributed with a mean of 1 million gallons and a c.o.v. of 40%, where as the total demand is expected to follow a lognormal distribution with a mean of 1.5 million gallo..
Explain how these effects were initiated : Is it possible (in this part of the world) for the sun to ever shine directly upon the OUTSIDE of a NORTH-facing wall of a home or other building? If so when?
Determine the magnitude and the point of application the : Determine the magnitude and the point of application the resultant of the four wind forces (distance right of AB, and distance below BC) when a=1.5ft and b=13ft.
What is the required detention time and tank volume : A chlorination process is to be used to disinfect a wastewater treatment plant effluent. The plant treats 1.8MGD (million gallon per day). The water entering this unit has about 4500mg/L of coliforms, and the effluent target is 0.1 mg/L of coliforms.
How many pounds of sulphur would be emitted : Coal has about 5% sulfur. How many pounds of sulphur would be emitted from coal-fired power plants in the united states in 3 years? (each year. U.S electricity production in about 0.28 x 1012 watts, and coal has an energy content of about 30 x 106 J/..
What is the resulting solids concentration : Raw primary sludge at a solids concentration of 3% is mixed with waste activated sludge at a solids concentration of 6,000 ppm. The flows are 20 and 25 gal/min, respectively.

Reviews

Write a Review

Civil Engineering Questions & Answers

  Explain whether or not if the wire will fracture

Consider a tensile test on polycrystalline copper which has a yield strength of 20,000 PSI and a tensile strength of 40,000PSI. The engineering strain at maximum load in a tensile test was 25%.

  Determine the smooth concrete and the flow gain

Determine the discharge for (a) commercial steel (b) cast iron (c) smooth concrete and the flow gain if the highest capacity pipe material is chosen over the lowest.

  Find reservoir in acre-ft that would be required to contain

A hurricane has an average rainfall of 9 in over a 200 mile^2 watershed. What is the reservoir in acre-ft that would be required to contain 20% of the rain completely

  Determine value of force f which result in zero displacement

A rectangular steel bar shown is fixed at the right end has a thickness of 20 mm. The temperature is increased by 20C and a force F is applied as shown midway along the bar. Use the properties E=200 GPa, a=12(10^-6)/C.

  Estimate how much carbon must be purcahsed

Estimate how much carbon (in pounds) must be purcahsed for a typical 2-bed carbon adsorption system to treat 5000 cfm of air at 95 degrees F and 1 atm. The air contains 600 ppm of styrene.

  Determine the power produced by the turbine

A Rankine cycle has a boiler pressure of 2500 psi and a condenser pressure of 1psi. The temperature at the inlet of the turbine is 800F. The turbine has an isentropic efficiency of 90 percent and the pump operates isentropically.

  Determine the horizontal reaction

Determine the horizontal reaction that is developed on the gate at C.

  Why covalently bonded materials are generally less dense

Offer an explanation as to why covalently bonded materials are generally less dense than ionically or metallically bonded ones.

  Calculate the turning moment required to operate the gate

A pipe line of 1.25 m diameter has a circular gate at its end. This gate can be operated around its horizontal diameter. If the pipe is flowing full with velocity almost equal to zero, calculate the turning moment required to operate the gate

  Determine how many candy bars needs to take with woman

A 68 kg woman is planning to bicycle for an hour. If she is to meet her entire energy needs while bicycling by eating 30 g chocolate candy bars, determine how many candy bars she needs to take with her.

  Determine the maximum acceleration of the camera

The vertical velocity of the box at the time that it hits the surface is v= 5m/s. After impact the camera experiences an acceleration of a = -kx, where k is a constant and x is the compression of the packing material.

  Compute the coefficient of roughness with a bottom width

A trapezoidal canal with a bottom width of 2 m, a side slope Z=1.5, and a longitudinal slope of 0.0006 conveys a flow rate of 3 m^3/s. If the water depth in section 1 is 0.78 m and in section 2

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd