Estimate the hourly so2 and particle emissions

Assignment Help Civil Engineering
Reference no: EM13210909

A 2000-MW electric generating station burns 278 tonnes of residual fuel oil per hour. The fuel contains 2.6% S and 1.2% ash. The station is equipped with particle, sulfur dioxide, and nitrogen oxide emission control systems. The particle collector must operate at efficiencies exceeding 98% because the ash is valuable for its vanadium content. The sulfur dioxide removal device operates at a normal efficiency of 80%.

A) Estimate the hourly SO2 and particle emissions from the station.
B) What type of particle collector would you use at the station? Give three reasons for choosing this type of collector.
C) What type of SO2 removal device before (in front of) or after (following) the particle collector would you use?
D) How would you control the nitrogen oxide emissions?

 

Reference no: EM13210909

Questions Cloud

Identify the groups that did not share in general prosperity : Identify the groups that did not share in the general prosperity of Americans during the 1950s. Explain why each of these groups missed out on the “good times.
Define the highest boiling point : For which substances would you predict the highest boiling point? Answer with explanations as to why?
Determine appropriate insurance coverage : Explain risk management and its importance and identify types of risk and how you can manage and determine appropriate insurance coverage by investigating options for property and vehicle.
Define substances would be expected to be the most soluble : Which of the following substances would be expected to be the most soluble in CCl4? Answer with explanation as to why. a)NH3
Estimate the hourly so2 and particle emissions : what type of SO2 removal device before (in front of) or after (following) the particle collector would you use?
How far downstream would you establish barricades : The fire department proposes to approach the truck from the upstream side and heavily spray the truck with water to prevent an explosion. Will this help to reduce the chlorine concentration downstream?
What does line of collimation means : How to detect eror in line of collimation and what does line of collimation means.
Cost of ordinary share capital : Calculate the weighted average cost of capital of Riphean plc and Silurian plc using the information provided and discuss two possible reasons why the cost of ordinary share capital differs between the two businesses
Explain the change in total pressure within the chamber : What is the change in total pressure within the chamber following the reaction? Assume a constant temperature throughout the process.

Reviews

Write a Review

Civil Engineering Questions & Answers

  Discharged of wastewater to aquifer

Wastewater is discharged into an aquifer. This wastewater contains 0.1 ppm atrazine (a common herbicide). The MCL of atrazine is 5 ppb, the density is 1.19 g/mL and the solubility is 50 ppm. 500 ft away from the plant effluent there is a permeable..

  Calculate the ratio of area to volume for unit cube

calculate the ratio of area to volume for unit cube a unit sphere in inscribed inside the cube, and as write cylinder inscribed inside the cube.

  How much force must be applied to keep the gate \

A gate (shaped like .25 of a cylinder with radius R=3m) is used to control the flow of water through a canal.The height of the water in the tank is 30m. How much force must be applied to keep the gate from opening? The gate is 30m wide.

  Length of contracted rectangular weir

A trapezoidal canal 6m wide at the bottom and having a side slope of 1V:2H carries water with a mean velocity of 1.0m/s to a depth of 60cm. What length of contracted rectangular weir 1.0m high should be placed at the middle of the canal to make th..

  What is the level of the service of this compound-grade

If the peak-hour factor is .90 and all of the drivers are regular users, what is the level of the service of this compound-grade freeway segment?

  Probelm relating to fire a bullet

A bullet is fired from a height of 150m at a velocity of 300kmph at an angle of 35 upward. Neglecting air resistance. Find: a) total time of flight b) horizontal range

  Commencement of fill placement

Determine the horizontal spacing of the vertical drains if the drains are installed in triangular grid to reach 90% of primary consolidation in 1.5 years after the commencement of fill placement.

  Wall shear stress and friction velocity

A rectangular channel 5 m wide carries a discharge of 10 m^3/s at a uniform depth of 3 m. The channel is running on a slope of 0.0025 m/m. Estimate wall shear stress and friction velocity. Assume the density of flowing water as 1000 kg/m^3.

  Determine the relevant pi groups

The break up of a liquid jet into droplets of diameter d depends on the jet diameter D, the jet velocity V, viscosity Mu, density rho,and surface tension sigma.

  Installation of motor on pw criterion

At the end of 15 years, the first motor will have a salvage value of $50 and the second motor will have a salvage value of $100. consider the MARR to be 8%. (note : 1HP=0.7457 kw). Determine which motor should be installed based on the PW criterio..

  Bonding agents found with clay minerals

Describe the given types of bonding agents found with clay minerals. a) hydrogen bond b) covalent bond c) van der walls forces d) james bond e) ward bonds f) war bonds.

  Specify the amount of convective acceleration

shaped nozzle such that the velocity along the center line of the flow increased from 1.5 m / s to 15 m / s at a distance of 37.5 m. specify the amount of convective acceleration at the beginning and end of the range.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd