Estimate the discharge in a rock-bedded stream

Assignment Help Civil Engineering
Reference no: EM13326236

Estimate the discharge in a rock-bedded stream (d84=30cm) that has an average depth of 2.21m, a slope of 0.0037, and a width of 48m. Assume ks=d84.

Reference no: EM13326236

Questions Cloud

What is their distance of closest approach : A proton and an alpha particle (q = +2e, m = 4 u) are fired directly toward each other from far away, each with an initial speed of 0.012c. What is their distance of closest approach
Express mass moment of inertia of solid with respect to x : The area shown is revolved about the x axis to form a homogeneous solid of revolution of mass m. Using direct integration, express the mass moment of inertia of the solid with respect to the x axis in terms of m and h
How does the power ouput of the quasar compare : A quasar 10 billion light years from Earth appears the same brightness as a star 5.9*10^4 light years away. How does the power ouput of the quasar compare with that of the star
Find the tension in the rope tied to the bucket : You swing a 3.25-kg bucket of water in a vertical circle of radius 0.960m. Find the tension in the rope tied to the bucket at the top of the circle
Estimate the discharge in a rock-bedded stream : Estimate the discharge in a rock-bedded stream (d84=30cm) that has an average depth of 2.21m, a slope of 0.0037, and a width of 48m. Assume ks=d84.
Determine the normal and shearing stresses at point : Three forces are applied to the bar. Determine the normal and shearing stresses at (a) point a, (b) point b, (c) point c.Assuming that the 750-N force is directed vertically upward.
Which state had a smaller population : According to the 2010 census, the population of Nebraska was 1.8 x 10^6 people. Which state had a smaller population?
Explain the applicable rules of law : State and explain the applicable rules of law, such as the applicable constitution provision, statute, regulation, or common law principle
What size galvanized iron pipe is required to carry a flow : what size galvanized iron pipe (e=0.0005ft) is required to carry a flow of 5 cfs of water at 60 degrees F (v=1.217X10^-5) without exceeding a head loss of 5.0 ft/100ft of pipe

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine what is the radius of gyration of the wheel

A 500 lb flywheel is shown. A 100 lb block is held by a light cable wrapped around the hub of the flywheel the radius of which is 2 ft. If the system is released from rest and the weight has a velocity of 11 ft/sec after 5 s

  Determine rate of production of final product nd composition

An ethanol plant distills alcohol from corn. The distiller processes 2.0 t/h of feed containing 15% alcohol and 82% water; the rest is inert material. The bottoms (waste) produced is 85% of feed and contains 94% water, 3.5% alcohol, and 2.5% inert..

  Determine the flow rate of the oil

Oil of a specific gravity of 0.75 is flowing through a 6-in pipe under a pressure of 15 psi. If the total energy relative to the datumplate is 8.0 ft below the center of the pipe is 58.6 ft, determine the flow rate of the oil.

  Determination of edta titration

Does the presence of Mg2+ significantly interfere with the determination of Ca 2+ by the EDTA titration?

  Shear force-bending moment diagrams

A three-span continuous beam ABCD with three equal spans supports a uniform load with intensity q. Determine all reactions of this beam and draw the shear force and bending moment diagrams labelling all critical ordinates.

  Calculate the surface area of the clay particles

The surface area of clay particles can be determined by measuring the number of adsorbate molecules it takes to form a monolayer. The adsorbate molecules used for these measurements are usually N2 gas, therefore partial pressure "P" is used instea..

  Define water circulating through it at the rate

A 4 X 8-ft solar collector has water circulating through it at the rate of 1.0 gallon per minute while exposed to sunlight with intensity 300 Btu/ft^2-hr.

  Find what is the ratio of the flow rates in the two pipes

Two pipes of identical length and material are connected in parallel. The diameter of one is twice the diameter of the other. What is the ratio of the flow rates (Q2/Q1) in the two pipes

  Estimate range of piezometric head differences to be used

A field sample of medium sand with median grain size of 0.84 mm will be tested to determine the hydraulic conductivity using a constant-head permeameter. The sample has the length of 30 cm and a diameter of 5 cm.

  Determine the maximum theoretical speed that may be achieved

Determine the maximum theoretical speed that may be achieved over a distance of 60 m by a car starting from rest, knowing that the coefficient of static friction is 0.80 between the tires and the pavement

  Find an expression for the diameter of the droplet

find an expression for the diameter, D, of the droplet, in terms of the specific weight and surface tension, assuming the contact angle just before seperating is zero.

  Design a series of closely spaced parallel box beams

Design a series of closely spaced parallel box beams that will support an asphalt road surface over a 10 foot wide, 40 foot long span. The hollow box beams are made of concurred and imbedded No. 8 steel rods (1 inch dia.).

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd