Determine the normal and shearing stresses at point

Assignment Help Civil Engineering
Reference no: EM13326235

Three forces are applied to the bar. Determine the normal and shearing stresses at (a) point a, (b) point b, (c) point c.Assuming that the 750-N force is directed vertically upward.

Reference no: EM13326235

Questions Cloud

Express mass moment of inertia of solid with respect to x : The area shown is revolved about the x axis to form a homogeneous solid of revolution of mass m. Using direct integration, express the mass moment of inertia of the solid with respect to the x axis in terms of m and h
How does the power ouput of the quasar compare : A quasar 10 billion light years from Earth appears the same brightness as a star 5.9*10^4 light years away. How does the power ouput of the quasar compare with that of the star
Find the tension in the rope tied to the bucket : You swing a 3.25-kg bucket of water in a vertical circle of radius 0.960m. Find the tension in the rope tied to the bucket at the top of the circle
Estimate the discharge in a rock-bedded stream : Estimate the discharge in a rock-bedded stream (d84=30cm) that has an average depth of 2.21m, a slope of 0.0037, and a width of 48m. Assume ks=d84.
Determine the normal and shearing stresses at point : Three forces are applied to the bar. Determine the normal and shearing stresses at (a) point a, (b) point b, (c) point c.Assuming that the 750-N force is directed vertically upward.
Which state had a smaller population : According to the 2010 census, the population of Nebraska was 1.8 x 10^6 people. Which state had a smaller population?
Explain the applicable rules of law : State and explain the applicable rules of law, such as the applicable constitution provision, statute, regulation, or common law principle
What size galvanized iron pipe is required to carry a flow : what size galvanized iron pipe (e=0.0005ft) is required to carry a flow of 5 cfs of water at 60 degrees F (v=1.217X10^-5) without exceeding a head loss of 5.0 ft/100ft of pipe
Calculate the effect of the moon on your weight : Your weight is due to the gravitational attraction of the Earth. The Moon, though, also exerts a gravitational force on you, and when it is overhead, Calculate the effect of the Moon on your weight

Reviews

Write a Review

Civil Engineering Questions & Answers

  Calculate the axial and radial strains and volumetric strain

A cylindrical soil, 75mm in diameter and 150 mm long, is radially compressed. The length increases to 153 mm and the radius decreases to 37.2 mm. Calculate: a) The axial and radial strains b) The volumetric strains

  Determine what is the largest value of the force f

The weight of the box is 20 lb and the coefficient of static friction between the box and the floor = 0.65. Neglect the weights of the bars. What is the largest value of the force F that will not cause the box to slip

  Determine total stress and pore water pressure of sand

a layer of clay, 5m thick, overlies a deposite of sand, 5m thick, which is underlaid by rock. the water table in the sand is sub-artesian with a level at 2m below fround level. the saturated unit weights of the clay and sand are 21 and 16 KN/m^3 r..

  Estimate liquid volume of an aeration tank required to treat

Estimate the liquid volume of an aeration tank (units of m^-3) required to treat the following wastewater to a BOD effluent standard of 30.0 mg L^-1 and a suspended solids effluent standard of 30 mg L^-1.

  Determine the maximum acceleration of the camera

The vertical velocity of the box at the time that it hits the surface is v= 5m/s. After impact the camera experiences an acceleration of a = -kx, where k is a constant and x is the compression of the packing material.

  Calculate the carbon content required at surface of steel

A 0.02wt% C steel is to be carburized at 1200°C in 4 hrs with a point 0.6mm beneath the surface reaching 0.45wt%C. calculate the carbon content required at the surface of the steel.

  Determine the number of truck loads required to obtain

For construction of an embankment, the soil is transported from a borrowed area using a truck which carries 5.5 m^3 of soil at a time, with the following details: For the Borrowed Pit: bulk unit weight= 16 KN/m^3 and moisture content = 6.7%

  What is the standard deviation of total weekly waiting time

Suppose your wait time for a shuttle bus in the morning is normally distributed with µ=8 minutes and t1=5 minutes. Due to increased congestion in the afternoon, your wait time for a shuttle bus in the afternoon is normally distributed

  Determine how many days per year would have to operate

A contractor is considering the purchase of an earthmover to avoid the cost of a rental unit. The earthmover costs $350,000 initially and will cost $7000 per year to store and maintain.

  Determine the minimum horizontal force necessary for man

Determine the minimum horizontal force necessary for 200 lb man to scale crevice (using his feet and back). The coefficient of static friction between his shoes and his back against the wall is 0.4.

  Design hydro cooling unit that can cool fruits and vegetable

The unit will be of flood type, which will cool the products as they are conveyed into the channel filled with water. The products will be dropped into the channel filled with water at one end and be picked up at the other end.

  Find power rating of electric heater required to maintain

A room 7m x 6m x 3m high is to be electically heated to maintain the inside temperature at 20 C, when it is 0 C outside. The room has 2 windows each 1.2m x 1.8m and a sliding glass door 2.4m x 2.1m.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd