### Determine whether the crystal structure for this alloy is

Assignment Help Civil Engineering
##### Reference no: EM13544586

Some hypothetical alloy is composed of 12.5 wt% of metal A and 87.5 wt% of metal B. If the densities of metals A and B are 4.27 and 6.35 g/cm3, respectively, whereas their respective atomic weights are 61.4 and 125.7 g/mol, determine whether the crystal structure for this alloy is simple cubic, face-centered cubic, or body-centered cubic. Assume a unit cell edge length of 0.395 nm.

### Write a Review

#### Determine the ntu values for each sampling port depth

The packed tower was 30 cm in diameter with sampling ports located at packing depths of 0,2,4,6,8,10, and 12 meters. The loading of water to the tower was 0.039 m^3/(m^2/s), and the temperature of groundwater was 10 degrees celcius.

#### Determine what is the probability that all four have defect

If the defect rate for the flash drivers is 0.5% and you randomly select four of them for inspection: a) What is the probability that none of them has a defect b) What is the probability that all four have a defect

#### Determine the tension in each of the cables at a time

A long trough is supported by a hinge along its lower edge and a series of horizontal cables attached to its upper edge. Determine the tension in each of the cables, at a time when the trough is full of water.

#### How many cubic yards of aggregate must be ordered

how many cubic yards of aggregate must be ordered for a road base 16 inches thick and 2000 feet long with a top width of 30 ft, if the side slopes are one on one, or 45 degree

#### Describe what are the different dimensionless groups

What are the different dimensionless groups that describe a golf ball. A golf ball has two velocities, a spin velocity and a forward velocity.

#### Compute the criteical stress required for the propagation

If the specific surface energy for aluminum oxide is 0.90 J/m^2, using data contained, compute the criteical stress required for the propagation of an internal crack of length 0.40 mm.

#### What is the normal depth in 4-foot wide rectangular channel

What is the normal depth in a 4-foot wide rectangular channel that conveys a discharge of 100 CFS and has a bed slope of 2% with a Manning's roughness coefficient of 0.025

#### What is the elevation at point 2 and the pressure at point 3

A buried stock-water pipeline conveys water from a water source at Point 1, rises to pass up and over the peak of a hill (Point 2) before falling to Point 3 in the pipeline some

#### What is the maximum distance away that the navigation lights

What is the maximum distance away that the navigation lights can still be seen by an observer standing at the shoreline The observer's eye height is 5'6" and the uppermost navigation light is 168 above the water.

#### What will be change in partial pressure of carbon dioxide

A stack gas at 1.1 atmospheric pressure has a mixture below. what will be the change in partial pressure of carbon dioxide if the gas temperature is lowered from 2000 degrees K to 1000 degrees K

#### What is the elongation of a rectangular bar to an axial load

What is the elongation of a rectangular bar (cross section 2 inch * 2 inch length 4 ft) When it is subjected to an axial load of 80,000 lbs. Assume the material of the bar has the following properties G = 7,700 KSI, V =0.30

#### Isotropic and homogenous hydraulic conductivity

Assuming an isotropic and homogenous hydraulic conductivity of 0.0001 cm/s what is the magnitude and direction of specific discharge (q)?

#### Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!