Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Liquid propane is commonly used as a fuel for heating homes, powering vehicles such as forklifts, and filling portable picnic tanks. Consider a propane tank that initially contains 5ml of liquid propane at the environment temperature of 20 Celsius. If a hole develops in the connecting tube of a propane tank and propane starts to leak out, determine the temperature of propane when the pressure in the tank drops to 1 atm. Also determine the total amount of heat transfer from the environment to the tank to vaporize the entire propane in the tank.
Oil (SAE 30) flows between parallel plates spaced 5mm apart. The bottom plate is fixed, but the upper plate moves with avelocity of .2 m/s in the positive x direction. The pressuregradient is 60 kPa/m, and is negative.
A water sample contains 118mg/L of bicarbonate ion, 19mg/L of carbonate ion, and has a pH of 9.5. What is the alkalinity of this water expressed as mg/L of CaCO3
two solid rods AB and BC are welded together at B and loaded as shown. Knowing that d1=50mm and d2=30mm, find average normal stress at the midsection of rod AB and rod BC.
(a) Calculate the annual costs ($/yr) of meeting the proposed effluent requirement of 0.1 mg P/L using alum to precipitate AlPO4(s). Assume the chemical formula for alum is Al2(SO4)3·18H2O (MW = 666).
The outer surface of the tank is cooled by air at 300 K with a heat transfer coefficient of 100 W/m2K. Determine the maximum temperature in the tank. Take the thermal conductivity of the wastes as 2.0 W/mK.
Determine the magnitude of F2 which will cause the reaction Cy at the bearing C to beequal to zero. The bearings are in proper alignment and exertonly force reactions on the rod. Set F1 = 550 lb.
Determine the degree of saturation of a sample of soil given that its maximum dry unit weight is 18 kN/m^3 and its optimum moisture content is 12.1%. Assume the Specific Gravity of soil is 2.65.
The slope distances shown were measured with an EDM while the differences in elevation between the ends of each line were determined by leveling. What are the horizontal distances
A 100 ft cut steel tape was used to check the layout of a building wall. the rear surveyor held 42 ft while the head surveyor cut 0.33 ft. what is the distance measured?
A toxic compound being is removed from solution in a CSTR at Steady State according to a first order reaction rate. The upstream concentration of the pollutant is 14 mg/L and the downstream concentration is 1.7 mg/L.
Draw the S.F.D and B.M.D for the beam as a single unit and determine the position and amount of hte maximum bending unit. 5kN 30kN 5kN A B C D E 2m width 2.5m width 2.5m width 2m width 20kN 20kN
A canal of rectangular cross-section and an n=0.030 is to be laid on a slope of 0.002 and is to carry a discharge of 30 m3/s. Calculate the cross-sectional area required for the channel to carry this flow based on the norma
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd