Determine what will current be and what will the power be

Assignment Help Civil Engineering
Reference no: EM13303293

suppose we have a 100-volt battery connected with a 100-ohm resistance. The current is then 100/100=1 amp. how much power is produced? if we double the voltage, what will the current be and what will the power be?

Reference no: EM13303293

Questions Cloud

Find is the cyclist ahead of or behind the car : At rest, a car's horn sounds the note A (440 Hz). The horn is sounded while the car is moving down the street. find Is the cyclist ahead of or behind the car
Determine the initial weight and final density of the water : A steel tank hold 120 ft^3 of water at atmospheric pressure(14.7psi and 68.4 degrees f). the water is subjected to a 100 fold increase in pressure. determine the initial weight and final density of the water if the volume decreases by .545 ft ^3.
Determine the minimum length of curve that can be designed : you are designing a highway to AASHTO guidelines on rolling terrain where the design speed will be 65 mi/hr. At one section, a +1.25% grade and a -2.25% grade must be connected with and equal tangent vertical curve.
Calculate the intensity of the sound wave emitted : The toadfish makes use of resonance in a closed tube to produce very loud sounds. The tube is its swim bladder, used as an amplifier. Calculate the intensity of the sound wave emitted
Determine what will current be and what will the power be : suppose we have a 100-volt battery connected with a 100-ohm resistance. The current is then 100/100=1 amp. how much power is produced. if we double the voltage, what will the current be and what will the power be.
What is the half-life of this radioactive material : 25% of a radioactive material stays active after 4 hours. What is the half-life of this radioactive material
Define er diagram and database implementation : Development of an ER Diagram and Database Implementation- Course Objectives: This assessment task focuses on the following course objective -ITECH1006
Compute the kinetic energy of the aircraft : Type your question hereAn aircraft with a mass of 963 kg accelerates from 0 to 80 m/s in 8.1 seconds, What is the kinetic energy of the aircraft
Determine value of force f which result in zero displacement : A rectangular steel bar shown is fixed at the right end has a thickness of 20 mm. The temperature is increased by 20C and a force F is applied as shown midway along the bar. Use the properties E=200 GPa, a=12(10^-6)/C.

Reviews

Write a Review

Civil Engineering Questions & Answers

  What is the amount of gas in the container in units of grams

n ideal gas in 1.50 gallon container is at a temperature of 125 degrees Celsius and of 2.5 atmospheres. If the gas is oxygen (formula: O_2, molecular weight = 32 grams per mole), what is the amount of gas in the container in units of grams

  Calculate by what factor the mass of propane has increased

A typical propane tank that we use for barbeque initially contains a pressure of 10 psi. The pressure is low, so we take it to the local store to fill the tank with more propane. After filling,the pressure is 100 psi.

  How much energy do methanogenic bacteria get from h2

How much energy do methanogenic bacteria get from using glucose and hydrogen (H2) to form methane and water as the products. Determine the net reaction (assume methane and water are the only products).

  Calculate the bearing stress on the shaft key

A rotating shaft with an applied torque of 400 Newton-meters is held in place (stopped) by a shaft key. The diameter of the shaft is 15 centimeters. The shaft key has a length of 20 cm, and is square, with its width and height being 5 cm.

  Existing equal tangent sag curve

An overpass is being built over the PVI of an existing equal tangent sag curve. The sag curve has a 70 mi/h design speed, and G1 = -6%, G2 = +3%.

  When would the wells start interfering with each other

one of the wells pumps at a rate of 1240 m3/day. the second well pumps at 850 m3/day.if the aquifer has a transmissivity of 2000 m2/day and a storage coefficient of 4x10^-4, when would the wells start interfering with each other.

  What bolt sizes must be used for the allowable shear stress

A structural steel beam is attached to a column with bolts. The downward force on the connection is 150 kips. What bolt sizes must be used if the allowable shear stress is 25.0 ksi

  Coefficient of static friction between pacakges

The belt starts from rest at time t=0 and its speed increases at a constant rate of 150mm/s^2. Knowing that the coefficient of static friction between the pacakges..

  Determine what is the present worth of benefit

A flood control project has a construction cost during the first year of $10 million, during the second year $6 million, and during the third year $2 million. It is completed at the end of the third year and thereafter incurs an annual operating c..

  Define mechanical engineering dynamics

Important information about Mechanical engineering dynamics, A 3000 lb car rests on a horizontal street out of gas with its brakes locked.

  What is the level of service on a km long percent upgrade

A rural freeway has an ideal free-flow speed of 120 km/h and two 3.6 m lanes in each direction, with right shoulder lateral clearance of 1.2 m. Interchanges are spaced approximately 5 km apart. Traffic consists of 10 percent trucks and buses and 8..

  How to solve for the deficit concentration as function of x

Develop the mass balance equation and solve for the deficit concentration as a function of x, u, Lo, Do, ka, kd,and ks in the stream. Lo ans Do are the initial concentrations of BOD and DO deficit in the stream at x

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd