Determine what is the torque of shaft be

Assignment Help Civil Engineering
Reference no: EM13318838

if shaft A have 1200N.m torque with 25cm diameter and the shaft B have diameter of 52cm what is the torque of shaft be

Reference no: EM13318838

Questions Cloud

How many pounds of solids enter the plant every year : A wastewater treatment plant receives 15 mgd of flow, with solids concentration of 230 mg/L. How many pounds of solids enter the plant every year
Determine thermal efficiency of cycle and net power output : The steam exits the high-pressure turbine at 2 MPa, is reheated to 550 degree Celsius, and then expanded through a low-pressure turbine to 50 kPa.
Explain the new volume v2 of the balloon in liters : The initial volume of the balloon is 5.00 L, and the pressure is 760 mmHg. The balloon ascends to an altitude of 20 km, where the pressure is 76.0 mmHg and the temperature is -50 degrees celsius. What is the new volume,V2 , of the balloon in liter..
Calculate the maximum height reached by the ball : A ball is thrown initial 10m/s at 30 degree above horizon from a platform of 20 meter above the ground. calculate the maximum height reached by the ball
Determine what is the torque of shaft be : if shaft A have 1200N.m torque with 25cm diameter and the shaft B have diameter of 52cm what is the torque of shaft be
Determine the total magnification : The focal length of the objective and eyepiece in a compound microscope are 0.8 cm and 2.5 cm, respectively. What is the total magnification
The e-health model of health delivery : How should information from the e-Health model of health delivery be presented to patients without needlessly alarming them? Should health information from providers and the consumer be co-mingled? Why or why not?
Blast fume clearance time : Determine concentration of fumes after they have spread throughout the drive but before they have entered the decline
What is the amplitude of the oscillations : A simple harmonic oscillator consists of a block of mass 1.70 kg attached to a spring of spring constant 144 N/m. What is the amplitude of the oscillations

Reviews

Write a Review

Civil Engineering Questions & Answers

  Parallel tangents of a reversed curve

The perpendicular distance between two parallel tangents of a reversed curve is 20m. The azimuth of the back tangents of the curve is 270 00 and the azimuth of the common tangent is 310.

  How high can that person climb the ladder before the slip

A ladder is supported by a horizontal floor and a vertical wall. Is 15 feet long and weighs 50 lbs, with the weight concentrated at its midlength. The ladder supports a person weighing 180 lbs.

  Estimate the minimum absolute pressure causing cavitation

When a fluid flows through a sharp bend, low pressures may develop in localized regions of the bend. Estimate the minimum absolute pressure (pmin in psi) that can develop without causing cavitation if the fluid is water at 80 oF.

  Determine the length of the channel for the n

A trapezoidal channel of bottom width 25ft and side slope 1:2.5 carries a discharge of 450cfs with a normal depth of 3.5 ft. The elevations at the beginning and end of the channel are 685 and 650 ft, respectively.

  How long will take until the height is 1 m above the orifice

A tank with a 3m diameter has an 8 cm orifice at the bottom. The tank is currently filled with water to a height of 2.5m above the orifice. If the orifice is opened, how long will it take until the height is 1 m.

  What is the net cash inflow from the sale for situation a

A $125,000 tractor trailer is being depreciated by the Stright Line method over five years to a final Book Value of zero. Half year convention does not apply to this asset, After three years the rig is sold for A

  Determine the total elongation of the steel rod

A steel rod having a cross sectional area of 1/2in^2 and length of 600ft is suspended vertically. It supports a load of 5000 pounds at the lower end. If steel weighs 490 lb/ft^3 and E=30,000,000 psi, find the total elongation of the rod

  What was the students associated perception reaction time

The student strikes the sign at a speed of 25 mi/h. if the student was travelling at 65 mi/h when the sign was first spotted, what was the student's associated perception reaction time

  Determine smallest values of c and k for static deflection

the turbopump unit in the engine nominally operates at 7000 rpm, and a result of design issue, the actual thrust provided by the engine oscillates harmonically with an amplitude of 10 KN at the same rotational frequency as the turbopump unit.

  How does the nature of the boundary layer affect lift

sitting on the deck one evening. watching for that pesky bunny, jon and his brother see a twig floating down from an aspen tree. (wait - os that a bunny) they wonder just what the boundary layer looks like on the twig.

  Compute stationing of pvc-pvi and pvt curve points

The profile of the bridge and tunnel. Devise a vertical alignment to connect the tunnel and bridge by determining the highest common design speed for the sag and crest (equal tangent) vertical curves needed.

  Determine the inclination theta of the ladder

Determine the inclination θ of the ladder if the coefficient of static friction between the friction pad A and the ground is μs= 0.3. Assume the wall at B is smooth. The center of gravity for the man is at G.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd