Determine what is the drag coefficient at the cars top speed

Assignment Help Civil Engineering
Reference no: EM13302393

A 3000-lb car has a maximum speed (at sea level and on a level, paved surface) of 140 mi/h with 16" radius wheels, a gear reduction of 3.5 to 1, and a drivetrain efficiency of 92%. It is know that at the car's top speed the engine is producing 220 ft-lb of torque. If the car's frontal area is 25 sq ft, what is it's drag coefficient?

Reference no: EM13302393

Questions Cloud

What is the centripedal acceleration of the child : A 40.0 kg child takes a ride on a Ferris wheel that rotates four times each minute and has a diameter of 18.0 m, What is the centripedal acceleration of the child
Then how much should you be willing to pay for the bond : Then how much should you be willing to pay for the bond? Round your answer to two decimal places.
Using npv method and a constant discount rate : Using NPV method and a constant discount rate of 12%, determine if the project is acceptable.
Calculate the present value and future valvue of this fund : To save for college, the Smiths open a fund in which they will deposit $2,000 per year for 18 years. Viewed as a continuous income stream and assuming an APR of 6 percent compounded continuously, calculate the present value and future valvue of th..
Determine what is the drag coefficient at the cars top speed : A 3000-lb car has a maximum speed (at sea level and on a level, paved surface) of 140 mi/h with 16" radius wheels, a gear reduction of 3.5 to 1, and a drivetrain efficiency of 92%. It is know that at the car's top speed the engine is producing 220..
What is the companys total tax liability : 1. Clinton Industries had $120,000 in taxable income in 2007. What is the company's total tax liability for the year?
Evaluate the molarity of of the solutions of methanol : calculate the molarity of of the following solutions 6.57g of methanol ( CH3 OH) in 1.50 x 10^2 mL solution
At which the driver could apply the brakes and still stop : The road is in good, dry conditions until 160 ft before the stalled car where it is wet and stays wet for the remaining length. What is the minimum distance from the stalled car at which the driver could apply the brakes and still stop before hitt..
What is the most you should pay for the annuity : You just inherited some money, and a broker offers to sell you an annuity that pays $5,000 at the end of each year for 20 years. You could earn 5% on your money in other investments with equal risk. What is the most you should pay for the annuity?

Reviews

Write a Review

Civil Engineering Questions & Answers

  Working of real estate salesperson

You are a real estate salesperson working for Good Earth, Realtors, Inc. You receive 50 percent of all commissions received by the firm (net of MLS fees) for which you were either the listing agent or the selling agent.

  How to estimate the concentration of a in the reservoir

The rate constant for decay of contaminant A in the reservoir is k=1.5 (1/year). Assuming the population, discharge rate, and reservoir conditions have been stable for a long time, estimate the concentration of A in the reservoir.

  Explain why the architects requires a deflection limitation

The buildings are single story with a rood line 6 feet above the man-door opening is constructed from clay brick that is 12 inches thick and weighs 115 psf. the opening of the man-doors are 3 feet 4 inches wide.

  Determine percent error in replacing sine and tangent angles

Determine the percent error n in replacing the sine and the tangent of an angle by the value of the angle in radians for angle values 5 degrees, 10 degrees, and 20 degrees. Explain the qualitative difference between the sine and tangent results

  Determine the tension t and the reaction at b and d

Two transmission belts pass over sheaves welded to an axle supported by a thrust bearing at B and a journal bearing at D. The sheaves A has a radius of 50mm, and the sheave at C has a radius of 40mm.

  Determine the maximum displacement of the plate

Determine the maximum displacement of the plate A if the billet strikes the plate with a speed of 8 . Neglect the mass of the springs, rollers and the plates A and B. Take = 4000 , = 40000 .

  Determine the compressive strengths of the following

Determine the compressive strengths of the following

  Define what must the drivers eye height in the van be

A civil engineering student contends that 60 mph is safe in a van because of the higher driver's eye height. If all other design inputs are standard, what must the driver's eye height in the van be for the student's claim to be valid

  Define the grade of the highway

The grade of the highway, Suppose that a highway rises a distance of 269 feet in a horizontal distance of 2647 feet.

  Thermal conductivities of aluminum and copper

The aluminum end and the copper end are maintained at temperatures of 50°C and 260°C, respectively. The thermal conductivities of aluminum and copper are 205 and 385 W/m · K, respectively. The temperature of the aluminum-copper junction in the rod..

  Give beam deflection solution

Beam Deflection Solution, Derive an expression for the deflection due to shear for a cantilever beam of constant rectangular cross section, under action of a point load, P at free end.

  Find the rate of change in volume

A water tank has a height of 120m, and its area of cross-section is 2000m. Water is released from the tank and the water level drops by 1 meter every minute. Find the rate of change in volume.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd