Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A driver is traveling 68 mi/h on a road with a -3% grade. There is a stalled car on the road 1000 ft ahead of the driver. The driver's vehicle has a braking efficiency of 90% and anti-lock brakes. The road is in good, dry conditions until 160 ft before the stalled car where it is wet and stays wet for the remaining length. What is the minimum distance from the stalled car at which the driver could apply the brakes and still stop before hitting it? Assume coefficient of rolling resistance of 0.013.
A steel bar is attached to a wood support beam with four 20 mm diameter lag screws. The steel bar is 75-mm-wide by 6-mm-thick. For the steel bar, the yield strength is 260 MPa and the ultimate bearing strength is 350 MPa.
What is the minimum distance from the stalled car at which the driver could apply the brakes and still stop before hitting it? Assume coefficient of rolling resistance of 0.013.
A 4.00-cm-diameter, 0.80-m long rod of aluminum 7075-T6 is subjected to an axial tensile force with a factor of safety of 1.75. The yield stress and modulus of elasticity of aluminum 7075-T6 are 500. MPa and 210. GPa, respectively.
Develop an estimate of the volumetric flow rate of air that will be required for aeration of the mixed liquor in an activated sludge system.For this calculation, assume that the (ultimate) CBOD is 200 mg/L and (ultimate) NBOD is 50 mg/L.
Use input values of epsilon (B1), pipe radius (B2), and Reynolds number (B3) to estimate "f" and place these in the same cells . Display the final answer in a message box and round to five figures. Use a short cut key of Ctrl+g
Set up a table showing curve elevations at the PVC, at the PVT, and at the half-station points along the curve. Compute the station and elevation of the curve turning point.
What are 3 of the equivalent fixed-point problems for f(x) = x2 - x -2=0?
How appropriate might a just in time inventory system be for a product such as roller skates?
A 300 mm diameter pipe is placed in a 3 m deep rectangular trench that is 0.60 m wide. The trench is backfilled with clay that has a bulk unit weight of 18.8 kN/m3. Compute the dead load due to backfill that the pipe must support.
A vertical crest curve has an approach grade +6% and a departure grade -6%. The Vertical intersection point level is 125 m. It is proposed to use a curve 720 m long. Calculate the level at TPl.
In 1800 an undeveloped country had a population of 10 million with birth and death rates of 60 and 52 per thousand per year. The situation continued until 1900, when the death rate instantaneously was reduced to 10
The horizontal motion of plunger and shaft is arrested by resistance of the attached disk which moves through the oil bath. If the velocity of plunger is v.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd