Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A manufactory company produces flash drivers and their products include: 1GB (10%), 2GB (10%), 4GB (20%), 8GB (30%), 16GB (20%) and 32GB (10%); in addition, there are four different colors for all the flash drivers: green, black, yellow, red and they are produced equally in amount for each color. If you randomly select a flash driver for inspection:
a) What is the probability of getting an 8GB flash driver with red color?
b) What is the probability of getting a 32GB flash driver with green or yellow color?
c) What is the probability of getting a flash driver which has the capacity more than or equal to 8GB with yellow color?
d) What is the probability of getting a flash driver which has the capacity less than or equal to 4GB with black or green color?
Knowing that its speed continues to increase at the same rate until it reaches 100 km/h at point C, 1) determine the speed at point B, and 2) the magnitude of the total acceleration when t = 20 seconds.
The car weights 2450 lb, the mechanical efficiency of the drivetrain is 90%, and the wheel radius is 14 inches. The base engine develops 200 ft-lb of torque, and a modified version of the engine develops 240 ft-lb of torque.
A 1m diameter pipe bend is carrying water with a steady flow rate of 2 m3/s. The bend has an angle of 90o and lies in a horizontal plane. The volume of water in the bend is 1.5 m3 and the empty weight of the bend is 4 kN.
The IIT components of ownership cost based on average annual value are: Tax-3%, Insurance -4%, and Interest-7%. a) What is the average annual value?
A finished 2 x 4 timber (actual size 1 5/8 in. x 3 1/2 in. x 10 ft long) is used as a fixed-end, fixed-end column. If the modulus of elasticity for the timber is 1600 ksi and a factor of safety of 3 with respect to failure by buckling is specified
Based on volume of a sphere V=4/3(pi)r^3, create a table of volume vs. radius allowing radius to vary from 2.0 to 10.0 cm in 1 cm increments. Graph the data from the table on log-log paper using radius as the independent variable.
Determine the force P required to move the wedge under the post. The coefficient of static friction between all surfaces is 0.25. The applied force F is 200 lbs and the angle alpha is 15 degrees.
How far apart must two 18 , diameter tanks be placed such that their stress overlap is not greaer than 10% of the contact stress at depths of 10, 20, and 30 m
The coefficient of friction between the crate and the floor is µs = 0.4 and µk = 0.3. If P is slowly increased until the crate starts to move and then remains constant, determine using energy methods the speed of the crate after moving 2 m.
The three blocks shown move move with constant velocities. Find the velocity of each block, knowing that the relative velocity of A with respect to C is 300 mm/s upward and that the relative velocity of B with respect to A is 200 mm/s downward.
The beams support one-way slabs, 6 inches thick that span 20 feet center to center. Assume that the beams are 16 inches wide and 24 inches deep. Determine the dead load in pounds per linear foot for the beams, from the concrete structure alone.
The uniform steel shaft has two gears attached to it at B and C, two frictionless bearings, and the motor. The motor generates 15kip·in and the gears consume 10kip·in and 5kip·in. Find the diameter of the shaft if the maximum rotation between A an..
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd