Determine the present worth for physical asset investment

Assignment Help Civil Engineering
Reference no: EM13314206

Determine the present worth (for an MARR of 10%), after taxes, for the physical asset investment below:
Inital Cost=$40,000, Estimated Salvage Value (@ year 5)=18,000, Actual Salvage Value (@ yr.5)=20,000, Depreciation: Straight-Line (No half -year convention), Life=5yrs, Annual Benefit=10,000, and tax rate=34%.

Reference no: EM13314206

Questions Cloud

How much further would the tortoise have gone : The three-toed sloth is the slowest moving land mammal. On the ground, the sloth moves at an average speed of 0.035 m/s, how much further would the tortoise have gone relative to the sloth
What is the seasonal factor for the third quarter : What is the slope of the regression equation developed when the Sales data are used to predict the Pounds and what is the seasonal factor for the third quarter?
What is the total charge on the interior : A charge +7.4 %u03BCC is placed at the center of the hollow spherical conductor with the inner radius 3.2 cm, What is the total charge on the interior
Find the angular acceleration of the merry-go-round : A merry-go-round starts from rest and accelerates uniformly over 11.0 s to a final angular velocity of 7.50 rev/min, Find the angular acceleration of the merry-go-round
Determine the present worth for physical asset investment : Inital Cost=$40,000, Estimated Salvage Value (@ year 5)=18,000, Actual Salvage Value (@ yr.5)=20,000, Depreciation: Straight-Line (No half -year convention), Life=5yrs, Annual Benefit=10,000, and tax rate=34%.
Is it important to include a policy that outlines the origin : Why is it important to include a policy that outlines the origin and scope of purchasing authority? What might happen if such a policy did not exist?
How long in hours will it take to reduce the concentration : One way to treat amd is to treat the metals in a holding pond. The first order rate constant is 10/day. The concentration in the water must be below 5 ppm. How long in hours will it take to reduce the concentration from 250 ppm to 5 ppm
What is the drivers average velocity : A driver travels 10 km east, 20 km north and 50 km in a direction 30 degrees south of west. What is the drivers average velocity if the trip takes 90 minutes
At what distance will the concentration of metals be 5 ppm : Assume the stream is 3ft wide and 1ft deep (assume a rectangular cross section. If the flow throught the stream is 1000 gallons/day and the concentration at the beginning of the stream is 250 ppm

Reviews

Write a Review

Civil Engineering Questions & Answers

  How is the spent carbon removed from the pressure contactors

Testing has already been completed on the water and the Usage Rate for the carbon is 0.4 pounds of carbon per 1000 gallons of water treated. The required EBCT is 20 minutes and the carbon longevity must be at least 6 months.

  Determine the unstretched length of spring

Determine the unstretched length of spring AC if a force P = 110 lb causes the angle theta = 60^circ for equilibrium. Cord AB is 2 {rm ft} long. Take k = 50;{rm lb/ft}

  Determine what is the mass of the particles collected

a stream f gas flowing at 3000 cfm has a particulate loading of 50gr/ft what is the allowable exit loading if 95 % collection efficiency is required. what is the mass of the particles collected

  Determine what length of new pipe is needed

a buried horizontal concrete pipe (n=0.012) of unknown length needs to be replaces. the length is not known because the original plans for the pipeline route have been lost. the pressure head drop along the segment that needs to be replaced is 29...

  Probability of pulling out vehicle at oncoming traffic

Assuming a standard driver reaction time of 2.5 seconds, what is the probability that the vehicle pulling out will get in an accident with oncoming traffic?

  Determine what will be the hydraulic conductivity of the gcl

If this GCL is used as a liner beneath a 55-ft high landfill with a waste unit weight of 45 lb/ft3, what will be the hydraulic conductivity of the GCL at the bottom of the landfill

  Determine what is the concentration of nox

At 100 km downwind (y=10m), what is the concentration of NOx in g/m^3. The wind speed at the top of the stack with a height of 100m is 6.5 m/s and an inversion layer of 750m Pressure air = 95kPa

  Sample of natural glacial-groundwater table

A sample of natural glacial till was taken from below the groundwater table. The water content was found to be 52%. Estimate the wet density, dry density, buoyant density, porosity and void ratio. Clearly state any necessary assumptions.

  Determine hydraulic conductivity of the aquifer in vicinty

The rate of water level change was measured when the water in the auger hole was 5 meters below the water table, and was determined to be 5 cm/s. Determine the hydraulic conductivity of the aquifer in the vicinity of the auger hole.

  Determine the coefficient of thermal expansion

Determine the coefficient of thermal expansion (in m/m.K) for the material over the temperature ranges - Determine i. the phases present

  What will be compacted volume of soil in cy at full site

In addition to performing the cut-and-fill operations, the contractor needs to excavate the entire building footprint to a depth of 8 feet for a basement construction made of concrete masonry perimeter walls supported by 2'-0" X 0'-10" continuous ..

  What are the masses of gravel-sand and water per cubic meter

The design of a concrete mix requires 1173kg/m3 of gravel in SSD condition, 582 kg/m3 of sand in SSD condition, and 157kg/m3 of free water. The gravel available at the job site has a moisture content of 0.8% and absorption of 1.5%

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd