Determine the number of bolts needed

Assignment Help Mechanical Engineering

Reference no: EM13217078

A lap joint needs to be designed using 20-mm diameter bolts to carry a load of 120 kN on the connecting plates. If the shear stress in each rivet is not to exceed 90 MPa, determine the number of bolts needed.

Reference no: EM13217078

Questions Cloud

Determine the radius of the crank r : Determine the radius of the crank R and the speed n of a slider crank mechanism, used in a shaker table. It is required that the average speed of the table is 5 m/s, and the maximum absolute acceleration is 3000m/s^2. Assume ratio R/L=0.2

Estimate the mass flow rate of fuel into the engine : Estimate the mass flow rate of fuel into the engine in kg/h.

Derive the linearised equation about the operation : For the pendulum shown in the figure,the restoring torque due to gravity is given by T=mgLsin(thita). Derive the linearised equation about the operation point thita=0.

Explain development of the design more effective : Explain and justify ideas that could have made the development of the design more effective. Support your recommendations with specific examples as appropriate.

Determine the number of bolts needed : A lap joint needs to be designed using 20-mm diameter bolts to carry a load of 120 kN on the connecting plates. If the shear stress in each rivet is not to exceed 90 MPa, determine the number of bolts needed.

Determine the braking force applied by the breaks : a fully loaded lorry has a mass of 10 tonnes and is travelling along a road at uniform velocity when the brakes are applied and the lorry is brought to rest. if the deceleration is 2m/s2 and the coefficient of rolling friction is 0.15, determine t..

Could the company be found guilty of motor vehicle homicide : The state charged the Todesca corporation with motor vehicle homicide, and the jury found the company guilty. The trial judge imposed a fine-of $2,500. The court of appeals reversed the conviction, and the prosecution appealed to the state's highe..

What is the initial velocity of block b : What is the initial velocity of Block B, constant acceleration of Block A, velocities of both blocks at t=3s, and the total distance traveled by block B from t=0s to t=3s?

Intensive and selective levels of distribution intensity : Identify the difference between intensive, exclusive, and selective levels of distribution intensity? Give an example of a product that would be best for each level of distribution.

User Account

All Pages