Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A tensile load of 50 000 lb is applied to a metal bar with a 0.6x0.6 in cross section and a gage length of 2 in. Under this load the bar elastically deforms so that the gae length increases to 2.007 in. and the cross section decreases to 0.599x0.599 in. Determine the modulus of elasticity and the poisson's ratio for this metal.
Soil have a void ratio of 0.68 as it exists in a borrow pit is to be excavated and transported to a fill site where it will be compacted to a void ratio of 0.45. The volume of fill required is 2500 m^3.
If the energy loss in the contraction is equal to \(V_1^{2}/2g\) where V1 is the average velocity upstream of the contraction, what is the depth of flow in the constriction. A lined rectangular concrete drainage channel is 10m wide and carries a..
At 25 C, approximately what pressure in MPa must be applied to water to reduce its volume by 2%
A turbine expands to a pressure of 10 kPa and a quality of 0.94. Determine the temperature T and the specific volume at this state.
Lab studies have shown that the rate constant associated with the process are as follows: k = 0.95 mg COD/mg VSS-day; Y = 0.48 mg VSS/ mg COD, half-saturation K = 85 mg COD/L; ke = 0.07 d-1.
Determine the quantity of lime and soda ash required to soften 1 mgd of the following water. Plan to achieve a hardness of 40 mg/L as CaCO3. Note that an excess of 35 mg/L of lime (CaO) is required to achieve 40 mg/L as CaCO3.
Determine the effective size as well as the uniformity coefficient and coefficient of curvature for each soil. Determine also the percentages of gravel, sand, silt, and clay according to (a) ASTM, (b) AASHTO, (c)USCS, and (d) the British Standard.
Estimate the liquid volume of an aeration tank (units of m^-3) required to treat the following wastewater to a BOD effluent standard of 30.0 mg L^-1 and a suspended solids effluent standard of 30 mg L^-1.
calculate the ratio of the area to volume for unit cube,a unit sphare inscribed inside the cube,and as right cylinder inscribed inside the cube.
A syringe is pointed vertically up in the air and a force of 5 lbs is applied to the plunger with a diameter of 0.5 inches. Assuming no losses in the system how high will the stream of water rise above the syringe
Online professor's response to: Probability problems, A very rich investor has a small amount of spare cash which she wishes to invest. She has four options to choose from.
Assume the plane is flying at an altitude of 32,810 ft (10 km), where the temperature is -8 C and the pressure is 250 mb. The Pitot-static tube measures a piezometric pressure difference corresponding to 1.206 psi. What is the airspeed in both m/s..
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd