Determine the maximum tension t that can be exerted

Assignment Help Civil Engineering
Reference no: EM13544451

If a hook can sustain a maximum withdrawal force of 250 N inthe vertical direction, determine the maximum tension, T, that can be exerted.

The vector T, points down in the fourth quadrant with the inside angle at 10 degrees.

Reference no: EM13544451

Questions Cloud

What is the maximum coefficient of road adhesion needed : A rear-wheel-drive 3000-lb drag race car has a 200-inch wheelbase and a center of gravity 20 inches above the pavement and 140 inches behind the front axle
What is the maximum shear stress in the liquid : If the viscosity of the liquid is 10–3 N-s/m2, what is the maximum shear stress in the liquid?
Determine graphically the magnitude and direction : The cable stays AB and AD help support pole AC. Knowing that the tension is 120 lb in AB and 40 lb in AD, determine graphically the magnitude and direction of the resultant of the forces exerted by the stays at A using (a) the parallelogram law, (b) ..
Calculate what is the frisbees rotational inertia : A 106g Frisbee is 18cm in diameter and has half its mass spread uniformly n the disk and the other half concentrated in the rim. What is the Frisbee's rotational inertia
Determine the maximum tension t that can be exerted : If a hook can sustain a maximum withdrawal force of 250 N inthe vertical direction, determine the maximum tension, T, that can be exerted.
Determine the amount of air added to the tank in lbm : A rigid tank contains 40 lbm of air in 20 psia and 70 degrees F. More air is added to the tank untill the pressure and temperature rise to 35 psia and 90 degrees F, respectively.
Find how far from the shoulders is mans center of gravity : A man doing a slow push-up is approximately in static equilibrium. His body is horizontal, with his weight of 757 N supported by his hands and feet, how far from the shoulders is the man's center of gravity
Describe and implement virtual local area networks : Describe and implement Virtual Local Area Networks on a computing network and compare and contrast dynamic routing, distance vector routing, and link-state routing protocols.
Find how much work is done by the gravitational force : A 5.0-kg object is pulled along a horizontal surface at by a 15 N force acting 20? above the horizontal. How much work is done by the gravitational force

Reviews

Write a Review

 

Civil Engineering Questions & Answers

  The development of complex algorithms that can mine mounds

The development of complex algorithms that can mine mounds of data that have been collected from people and digital devices have led to the adoption of data mining by most businesses as a means of understanding their customers better than before

  What flow rate of fresh water used to reduce concentrations

The new owners propose to flush the pond into their discharge pipe leading to the Atlantic Ocean, which has a salt concentration above 30,000 mg/L. What flow rate of fresh water (in m3/s) must they use to reduce the salt concentration

  Explain about pres-stressed concrete

Explain about pres-stressed concrete

  How to select and apporpriate value of gs for the soil

A strata of clean, light-colored quartz sand located below the groundwater table has a moisture content of 25.6%. The minimum and maximum void ratios of this soil are 0.380 and 1.109, respectively

  A railroad car that weighs 20000lb is traveling eastward

a railroad car that weighs 20000lb is traveling eastward with a velocity whose magnitude is 5 fps. a second car on the

  Determine the minimum length of a crest vertical curve

Determine the minimum length of a crest vertical curve if the grades are +4% and -2%, Design speed is 70 mi/h

  Determine the pressures and volumes at points a-b-c and d

A 1.00 mol sample of an ideal gas (gamma = 1.40) is carried through the Carnot cycle. At point A, the pressure is 25.0 atm and the temperature is 600 K. At point C, the pressure is 1.00 atm and the temperature is 400 K.

  Determine the scale of the project graphically andanalytical

Assume the following equations for the total benefit and totalcost of a reservoir project as afunction of scale, Q, expressed asmillion gallons water delivered per day(MGD):

  Determine elevation of point b from the elevation of a point

To determine the elevation of a point B from the elevation of a point A, which is 511.6 ft. When the transit was set up over the point A, the height of the transverse axis above that point was 4.92 ft.

  Determine what force p is required to hold the gate in place

The air above the liquid is under a pressure of 5 psig, and the specific gravity of the liquid in the tank is 0.80. If the rectangular gate is 6 ft wide and if y1 = 1 ft and y2 = 10 ft, what force P is required to hold the gate in place

  Calculate the cost per kg charged by these two suppliers

Our laboratory plans to use one, 10-liter tank of refrigerant 134a every week. So off you go to check the cost of fill-ups at the two possible suppliers. At Chem Mart, the filled tank is returned to you at 10 bar and 90 C for $10.00.

  Diameter circular concrete pile required to take a design

Using a safety factor of 2.00 and neglecting the pile dead weight, find the length of a 1' diameter circular concrete pile required to take a design load of 50 kips in a soil composed of two layers.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd