Determine the mass flow rate the power produced

Assignment Help Civil Engineering
Reference no: EM13554995

A Rankine cycle has a boiler pressure of 2500 psi and a condenser pressure of 1psi. The temperature at the inlet of the turbine is 800F. The turbine has an isentropic efficiency of 90 percent and the pump operates isentropically. The net work of the cycle is 1000kW of power. Determine: the mass flow rate,the power produced by the turbine, the rate of heat supplied to the boiler and the thermal efficiency.

Reference no: EM13554995

Questions Cloud

Determine the components fa and fb of the 4.2 kn force along : Determine the components Fa and Fb of the 4.2 kN force along the oblique axes a and b. Determine the projections Pa and Pb of F onto the a- and b-axes.
What will its velocity be the instant prior to impact : A 400kg baby grand piano is raised to the roof of a 100m building. If the cable breaks as it reaches this height, what will its velocity be the instant prior to impact
Do the results of this experiment support your analysis : Under the right conditions, it is possible, due to surface tension, to have metal objects float on water. Consider placing a short length of a small diameter steel (sp. wt. =460 lb/ft^3) rod on a surface of water
Find the safety factor of the wire against breaking : A closed tank is filled with a liquid. The pressure at the top of the tank is less than atmospheric pressure. Which of the following accurately represents the gage pressure distribution on the surface indicated?
Determine the mass flow rate the power produced : A Rankine cycle has a boiler pressure of 2500 psi and a condenser pressure of 1psi. The temperature at the inlet of the turbine is 800F. The turbine has an isentropic efficiency of 90 percent and the pump operates isentropically.
Determine the water content void ratio saturated unit weight : The wet mass of a sample of a saturated soil is 520grams. the dry mass, after oven-drying, is 400grams. determine the water content, void ratio, saturated unit weight, and effective unit weight.
Determine the specific gravity of the sand : A cylinder has 500cm^3 of water. After a mass of 100 grams of sand is poured into the cylinder and all air bubbles are removed by a vacuum pump, the water level rises to 537.5 cm^3. Determine the specific gravity of the sand.
Determine the tradeoff between the cost and the energy head : Two materials (wrought iron, ks = 0.046 mm, and galvanized iron, ks = 0.15 mm) are being considered for a new pipeline. The expected discharge is 0.15 m3/s. Both the head loss and cost are sought for. Wrought iron pipe costs 5 cents more than the gal..
What is the maximum theoretical coefficient of performance : The low temperature in a freezer is -20 C, and the discharge temperature is 35 C. What is the maximum theoretical coefficient of performance

Reviews

Write a Review

Civil Engineering Questions & Answers

  Calculate the distance upstream from the point of entry

A clean-earth channel, for which n=0.020, is 6m wide and lies on a slope of 0.005236. Water flows at 30m3/s through the channel and enters a reservoir. The water depth in the channel, just before the entry to reservoir, is 3m.

  Estimate the maximum load allowed on the pile with factor

A 250 mm- diameter and 16 m-long timber pile is driven into a sandy soil where f= 18 kN/m3 and f' = 34 degree. Estimate the maximum load allowed on the pile with a safety factor of 2.5.

  What will be the grade elevation at station

The grade elevation at station 25+00 is to be 946.52 ft. What will be the grade elevation at station 34+86.20 if the grade linerises at the rate of 1.785% between these two points?

  Describe electron and hole motions in a p-n junction

Briefly describe electron and hole motions in a p-n junction for forward and reverse biases;

  What should be the length of an aluminum wire of 6 mm

What should be the length of an aluminum wire of 6 mm in diameter so it can be twisted one full turn without exceeding a shear stress of 42 MPa G = 27 GPa.

  Determine what is the deflection of the manometer

An Air manometer is connected to each side of an orifice, with a diameter of 8 inches, in a pipe with a diamter of 12 inches. If a maximum flow rate is 5 ft^3/s, what is the deflection of the manometer

  Find the volume of the given solid region bounded

Find the volume of the given solid region bounded below by the cone z=sqrt(x^2+y^2) and bounded above by the sphere x^2+y^2+z^2=128. using triple intergrals

  Find an expression for the flowrate and average velocity

Water flows steadly in an open topped channel of rectangular cross section. The channel width is B and the depth of the water is D. The flow is designed using a rectangular coordinate system whose orgin is at the free surface midway

  Find the required diameter for single barrel culvert

The headwater elevation cannot exceed 544.4 ft MSL, without overtopping the roadway embankment. Find the required diameter for (a) a single barrel culvert and (b) twin barrels assuming a square edged entrance.

  Which alternative is inferior in the ford costs for two year

investing in the General Motors costs $10,000 today and pays back $11,500 two years from now. If investing in the Ford costs $8,000 today and pays back $4,500 each year for two years, which alternative is inferior

  Design rectangular duct and fan system to pull 40000 scfm

Design a 2:1 rectangular duct and fan system to pull 40000 scfm of air carrying a medium-density dust through an FCD (Final Control Device) with a P of 6.0 in. H2O.

  Determine how much area must the heat exchanger have

You have been assigned to design a heat exchanger to cool a gaseous process stream in a chemical plant. The stream flow at 20 kg/s and enters at 431 oK, It has a heat capacity of 3.45 J/g-oC , and needs to be cooled to 402 oK.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd