Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Refrigerant R134a enters the compressor of a refrigerator at 0.14 MPa and -10°C at a rate of 0.12 kg/s and leaves it at 0.7 MPa and 50°C. The refrigerant is cooled in the condenser to 24°C and .065 MPa and it is throttled to 0.15 MPa. Disregarding any heat transfer from lines between components, show the cycle on a T-s diagram and determine the heat removed from the refrigerated space, the power input to the compressor, the isentropic efficiency of the compressor and the coefficient of performance of the refrigerator.
Assume you are an observer standing at a point along a three- lane roadway. All vehicles in lane 1 are traveling at 30 mi/ h, all vehicles in lane 2 are traveling at 45 mi/ h, and all vehicles in lane 3 are traveling at 60 mi/ h.
If the Greenshields model describes the relationship between speed and density on the highway, the jam density of the highway is 112 veh/mi, and the mean free speed is 64.5 mph,
Assuming a standard driver reaction time of 2.5 seconds, what is the probability that the vehicle pulling out will get in an accident with oncoming traffic?
A hollow circular, gray cast-iron pipe supports a red brass rod and weight W = 2 kips, as shown. The outside diameter of the pipe is d = 6". If the allowable compressive stress in the pipe is 5000 psi and the allowable shortening of the pipe is 0...
Devise an absolute temperature scale where the boiling point of water at 1 atmosphere (101 kPa) pressure = 100 degrees in your scale. What is the ice point of water in your scale
how many students have heights (a) greater than 72 inches, (b) less than or equal to 64 inches, (c) between 65 and 71 inches inclusive, (d) equal to 68 inches. Assume the measurements to be recorded to the nearest inch.
An open system Brayton cycle has a heat input of 500 kW. The pressure ratio of is 15 and the mass flow rate of air through the engine is 1 kg/s. Right before compression the temperature of the air is 273K and the pressure is 70 kPa.
At a depth of 4 miles in the ocean the ppressure is 9520 psia. Assume that the specific weight at the surface is 64.0 lb/ft^3 and that the average volume modulus is 320000psi for the pressure range.
The number of flaws on a sheet of aluminum manufactured by a certain process follows a Poisson distribution. In a sample of 100m2 of aluminum, 200 flaws are counted.
How many mL of water will it take to get 10 pounds of dry aggregate to a moisture content of 5%. 1 kg=2.2 pounds
An aluminum alloy tube with an outside diameter of 2.9 in. and a wall thickness of 0.32 in. is used as a 19-ft-long column. Assume that E = 8300 ksi and that pinned connections are used at each end of the column.
Estimate the liquid volume of an aeration tank (units of m^-3) required to treat the following wastewater to a BOD effluent standard of 30.0 mg L^-1 and a suspended solids effluent standard of 30 mg L^-1.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd