Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A Brayton cycle with a regenerator uses air as the working fluid. The air enters the compressor at 283K and 0.1 MPa. The highest temperature in the cycle is 1073K and the pressure ratio across the compressor is 8. The isentropic efficiency of the compressor is 87% and 93% for the turbine. The air exiting the cool side of the regenerator is 10C cooler than the air entering the hot side. The cycle produces 150kW of power.
Using Constant specific heats
Determine:
a) The effectiveness of the regenerator
b) The mass flow rate through the system
c) The rate of heat addition
d) The rate of heat rejection
If the quantity of ash released from the power plant each minute were to be eventually despersed in 4,000,000 m^3 of air at 25 degrees Celsius and 1 atm, what would be its concentration expressed in ppm
The base engine develops 200 ft-lb of torque, and a modified version of the engine develops 240 ft-lb of torque. If the overall gear reduction ratio is 8 to 1, what is the maximum acceleration from rest (in ft/sec^2) for.
develop a spreadsheet application that will display in a table the values of modulus of elasticity Ec for concrete having unit weight ranging from 95 pcf to 155 pcf (in steps of 5 pcf) and compressive strength ranging from 3500 to 7000 psi
Given the following information, determine the required DO concentration in the treatment plant effluent discharge in order to ensure that at no point downstream the DO in the river drops below 4 mg/L:
The tunnel is supplied with 1500 kg dry air/h at 50°C and 10% RH, and the air leaves at 25°C in equilibrium with the product at 50% RH. Determine the moisture content of product leaving the dryer and the final water activity.
an existing water treatment plant is producing an average flow of 0.5 mgd. due to several limitations the plant only
The cylinder B is released from rest. Determine the speed of both masses (vA and vB) after B moves by h m. Also calculate the angular displacement for the pulley D. The diameter of the pulley D is 0.2 m. Neglect all friction.
The cost for maufacturing a component used in intelligent interface converters was $23000 the first year. The company expects the cost to increase by 2% each year. Calculate the presence worth over a 5 year period at an interest rate of 10% per ye..
After moving the bubble four divisions off center, the reading is 1.410 m. For 2-mm vial divisions, what is (a) the vial radius of curvature in meters and (b) the angle in seconds subtended by one division
Compute the electrical conductivity of a 7.4-mm diameter cylindrical semiconductor specimen 28 mm long in which a current of 0.20 A passes in an axial direction.
A pump having the characteristics given in figure 14.9 ( N=2133.5 rpm, n=35.6 rps, D=37.1 cm) pumps water at 25 degree C from a reservoir at an elevation of 366 m to a reservoir at an elevation
A tank with a volume of 5,000 gal contains salt solution at an initial concentration (C0*) of 70,000 mg/L, but the concentration in the tank (C) needs to be reduced to 500 mg/L. Two approaches are being considered
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd