Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Use the Rankine cycle. The boiler operates at a 1000 kpa with a maximum temperature of 30 degrees Celsius. The condenser is isobaric and operates at -5 degrees Celsius.
a) calculate the vapor quality leaving the turbine and the specific enthalpy exiting the turbine (in kj/kg).
b) determine the specific-work produced by the rankine cycle turbine (kj/kg), assuming it is ideal and adiabatic.
c) show the cycle on a t-s diagram.
d) determine the specific work required by the rankine cycle pump (in kj/kg), assume it is ideal and adiabatic.
e) determine the specific QH for the rankine cycle (kj/kg).
F) calculate the rankine cycle (thermal) efficiency.
g) Compare the required material strength and cycle efficiency of this rankine cycle with a carnot cycle operating with the same TH (30 degrees celsius) and TL is (-5 degrees celsius) by calculating the percent change in max pressure and thermal efficiencies. assume steam
The elastic modulus is 40 GPa, the yield stress is 150 MPa, the ultimate stress is 525 MPa, and the ultimate strain is 0.38 (mm/mm). Perform the following tasks for this material. compute the tangent modulus between yield stress and ultimate stres..
a power plant burns 150,000 tonnes (1 tonne = 1,000 kg) of coal each year. The coal has 2.5% sulfur content, and the air pollution control equipment removals approximately 94% of sulfur. Assume 10% of the sulfur content ends up in the ash.
At a wastewater treatment plant, FeCl3 (s) is added to remove excess phosphate from the effluent. Assume the following reactions occur: FeCl3(s) Fe3+ + 3Cl- Fe3+ + PO4 (3-) FePO4 The equilibrium constant for the second reaction is 10^26.4.
The average rate of flow measured in a gage at the outlet of the watershed was 30 m^3/sec. Estimate the water losses due to the combined effects of evaporation, transpiration, and infiltration due to ground water.
For the data given below, derive the 2-hr unit hydrograph for a watershed having a drainagearea of 216 km^2, assuming a constant baseflow of 20 m^3/s.
what criteria should Zachary use evaluate the project ?
During a particular 30-day period, the streamflow flowing into a reservoir averaged 5.0 m3/s. Water supply withdrawals from the reservoir averaged 136 mgd. The only other outflow from the reservoir was 9.4 cm of evaporation from the water surface.
CALCULATE THE REQUIRED DIAMETER OF STEEL TIE RODS NECESSARY TO SUPPORT A BALCONY. EACH ROD, SUSPENDED FROM A ROOF TRUSS, SUPPORTS A FLOOR AREA OF 7.0m^2. THE COMBINED BALCONT FLOOR LOAD IS 10.5 kPa
The back tangent gradient is -4 percent, the forward tangent gradient is 2 percent, and the elevation of the curve at station 48+50 must equal to at least 510ft. What is the required length of the curve?
Assume the rate constant for BOD decay is 0.2 d^-1, the mean velocity of the stream is 0.5 m s^-1, and the initial concentration is 100 mg L^-1 at x=0. Plot the resulting concentration with downstream distance x in km.
The U.S. Department of Energy (DOE) constructed a Darrieus vertical-axis wind turbine in Sandia, New Mexico. The machine is 60.0-ft tall and 30.0-ft in diameter, and swept an area of 1200 ft 2.
The settlement analysis for a proposed structure indicates that 6cm of settlement will occur in 4 yr and that the ultimate total settlement will be about 25cm. estimate (a) the ultimate total settlement and ..
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd