Determine require tube length using physical property values

Assignment Help Chemistry
Reference no: EM131373482

Problem Set

1. The wind chill that is experienced on a cold windy day is due to increased heat transfer from exposed human skin to the surrounding air. You are asked to come up with an expression for "wind chill" based on your knowledge of forced and natural convection. Wind chill expresses the equivalent air temperature that would be experienced by the body in natural convection when losing heat at the same rate as it does in forced convection to air at the ambient temperature. The average human body may be approximated as a 1.8 m vertical cylinder with an inner core diameter of 30 cm surrounded by a skin layer. The human skin can be modeled as a 3 mm-thick layer of fatty tissue (k = 0.2 Wm-1K-1) whose interior surface is maintained at a controlled temperature of 37°C. Based on these assumptions, establish relationships for predicting the wind chill for ambient temperatures between -15°C and 10°C and wind speeds between 5 and 40 mph.

2. Water at 45°C flows at a rate of 0.34 kgs-1 through a Teflon tube (k = 0.2 Wm-1K-1) of 20 mm outer radius and 3 mm wall thickness. The tube is mounted horizontally in quiescent air at a temperature of 15°C, and a thin electrical heating tape is wrapped around the outer surface of the tube.

a. Neglecting radiation exchange, calculate the heat flux that must be supplied by the tape to ensure a uniform water temperature of 45°C in the tube.

b. If the emissivity of the tape is 0.95 and the surroundings are also at 15°C, recalculate the required heat flux by accounting for radiation exchange.

c. If the heating tape delivers a uniform surface heat flux of 1 k Wm-2, what fraction of the power dissipated by the tape is transferred to the water in the tube in the absence of radiation exchange?

d. Accounting for radiation exchange, what fraction of the power dissipated by the tape is transferred to the water in the tube?

3. It is desired to heat engine oil to a mean temperature of 80 °C by passing it through a 5-mm-diameter tube with a constant wall temperature of 150 °C. The oil enters the tube at 45 °C and a mass flow rate of 1 kgs-1 . The thermophysical properties of engine oil at different temperatures are given below:

320 K:

p = 872 kgm-3 ;

c = 1,990 ikg-1K-1 ;

k = 0.141 Wm-/K/ ;

v = 1.62X10-4 m2s-i

340 K:

p = 860 kgm-3 ;

c = 2,080 ikg-1K-1 ;

k = 0.139 Wm-/K/ ;

v = 6.2X10-5 m2s-i

360 K:

p = 848 kgm-3 ;

c = 2,160 ikg-1K-1 ;

k = 0.137 Wm-1K-1 ;

v= 3.0X10-5 1712 S-1

a. Determine the required tube length using physical property values at a mean temperature of 62.5°C.

b. Calculate the actual entrance and exit Reynolds numbers. Is the assumed flow regime in the heat transfer calculations of part (a) correct? Recalculate the required tube length by properly accounting for the nature of flow in the tube.

Reference no: EM131373482

Questions Cloud

What have you learned about source integration : When it comes to integrations, which type (quote, paraphrase, summary) are you the most comfortable using? Why? What have you learned about source integration from reading the sample paper? Explain your answer
Which is the change in the electric potential energy : What is EPEfinal - EPEinitial, which is the change in the electric potential energy?
In what way is compliance different from conformity : In what way is compliance different from conformity? Which factor significantly decreased the likelihood of conformity in Solomon Asch's studies
Which of the following is a strength of experiments : Which of the following is a strength of experiments? While on a visit to a large city, you observe several billboards in which a series of lights seems to move. Which perspective in psychology would be most likely to study this phenomenon
Determine require tube length using physical property values : ChE 350- Determine the required tube length using physical property values at a mean temperature of 62.5°C. What fraction of the power dissipated by the tape is transferred to the water in tube in the absence of radiation exchange?
Confidence interval for the difference : Give a 95% confidence interval for the difference in the average percentage of commissions in research versus nonresearch brokerage houses.
Construct a confidence interval for difference in means : The standard deviations were 5.72% and 5.10%, respectively.5 Conduct a test for equality of means using α = 0.01 and construct a 99% confidence interval for difference in means.
Give the answer of muliple choice question : PSY/335:Watch the "Introduction to Designing Experiments" video located in this week's Electronic Reserve Readings. Copy and past link below for video.Complete the following quiz. Choose your response by highlighting your answer.
Arabic sentiment analysis : methodology proposed for arabic social sentiment analysis of Twitter tweets using natural language processing (NLP) and 3 supervised machine learning approaches that are the Support Vector Machines

Reviews

Write a Review

Chemistry Questions & Answers

  Steps in the mechanism for the following reaction

Show all the steps in the mechanism for the following reaction, When benzene is mixed with deuterated sulfuric acid, deuterium is slowly incorporated onto the ring. Show the mechanism for this reaction and explain how this relates the sulfonation of ..

  Prior to placing piece of metal into the graduated cylinder

This assignment inhibits chemistry Laboratory Questions.

  Write the structures of the saytzeff elimination

Write the structures of the saytzeff elimination

  Calculate ph - chemistry questions

Chemistry Questions on Calculate P H

  How many mols of hydrogen can produce

how many mols of H 2 can produce

  Analysis of corrosion mechanisms

Analysis of corrosion mechanisms and preventative measures

  Chemical and pharmaceutical science

Write an equation for the formation of an acetal from reaction of excess methanol with benzaldehyde in the presence of an acid catalyst.

  Calculate the approximate sulphur

Calculate the approximate SO 2 mass emission in lb/day.

  What is the structure - stereochemistry

What is the structure (including functional groups)? Stereochemistry (racemic or single enantiomer)?

  Design a qualitative analysis scheme

Design a qualitative analysis scheme

  What will be the resultant pressure

What will be the resultant pressure when the stopcock is opened?

  The 1h nmr spectrum

Integrals for some of the resonances in the 1H NMR spectrum are higher than they should be due to the shear number of hydrogens in this compound

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd