Design the continuous slab showing using the aci moment

Assignment Help Civil Engineering
Reference no: EM13562537

Design the continuous slab showin using the ACI moment coeficients assuming the service live load of 200 psf is to be supported in addition to the weight of the slabs. The slabs are to be built integrally with the end supports, which are spandrel beams. fy = 60,000 psi, fc' = 4000psi normal-weight concrete. Clear spans are  15 feet, 18 feet and 15 feet.  with the longitudal span of 38 feet.

Reference no: EM13562537

Questions Cloud

Calculate what frequency do you hear : A truck is traveling at 56 mi/h (25.2 m/s) down the interstatehighway where you are changing a flat tire. What frequency do you hear
What is the capacity of the intersection approach : A signalized intersection approach has three lanes with no exclusive left- or right-turning lanes. The approach has a 50-second green out of a 110-s cycle. The yellow plus all-red intervals for the phase total 5.2 s. If the start-up lost time is 2.2 ..
Find the amplitude of the resulting motion : A massless spring with spring constant 20 N/m hangs vertically. A body of mass0.15 kg is attached to its free endand then released. Find the amplitude of the resulting motion
Calculate the angular velocity w of the cylinder : The solid circular disk of uniform thickness is released from rest on the 60-degree incline. Calculate the angular velocity w of the cylinder and the magnitude v of the velocity of its center C after it has moved 10 ft down the incline
Design the continuous slab showing using the aci moment : Design the continuous slab showin using the ACI moment coeficients assuming the service live load of 200 psf is to be supported in addition to the weight of the slabs
Evaluate how far does the book slide : A 1 kg physics book lying on a 20 degree incline isattached to a 500g coffee cup. How far does the book slide
How much work was done in firing the projectile : A 2.0-kg projectile is fired with initial velocity componentsV0x=30 m/s andV0y=40m/s from a pointon the earth's surface. How much work was done in firing the projectile
What are the discharge and the flow velocity when the pipe : A horizontal curve on a single-lane highway has its PC at station 124 + 10 and its PI at station 131+ 40. The curve has a superelevation of 0.04 ft/ft and is designed for 65mph. What is the station of the PT?
Calculate the tangential velocity of the satellite : A satellite, mass of satellite=5850 kg, is in circular orbitof 4.1x10^5m above the surface of a planet, which has a radius of4.15x10^6m. calculate the tangential velocity of the satellite

Reviews

Write a Review

Civil Engineering Questions & Answers

  Magnitude of the acceleration of the train

The train passes point A with a speed of 30 m/s and begins to decrease its speed at a constant rate of at = - 0.25 m/s2. Determine the magnitude of the acceleration of the train when it reaches point B, where sAB = 412 m.

  What distance on 5 grade should be laid out with a tape

What distance on 5% grade should be laid out with a tape that measures 30.010 m under field conditions if the horizontal distance is to be 430.00m

  What is the required detention time and tank volume

A chlorination process is to be used to disinfect a wastewater treatment plant effluent. The plant treats 1.8MGD (million gallon per day). The water entering this unit has about 4500mg/L of coliforms, and the effluent target is 0.1 mg/L of coliforms.

  Which two reactions are occuring at the anode and cathode

Which of the following is true for a thermistor with a negative temperature characteristic A) Decreasing temperature produces decreasing resistance in the thermistor. B) Increasing temperature produces decreasing resistance in the thermistor.

  What is the discharge from the pipe

Flow occur  throught a sand-filled pipe with a cross-sectional area of 60 cm^2. If K is 10^-3 cm/s and the gradient is 0.01, what is the discharge from the pipe ?

  Determine an optimal production schedule for the month

For each radio produced during months 1 and 2, a $10 variable cost is incurred; for each radio produced during month 3, a $12 variable cost is incurred. The inventory cost is $1.5 for each radio in stock at the end of a month.

  What is the max length to which it may be stretched without

For an unknown alloy the stress at which plastic deformation begins is 400MPa and the modulus of elasticity is 120GPa. If the original specimen length is 76 mm

  Calculate the net volume of earthworks needed or available

The following data represents, in square meters, the cross-sectional areas along a short portion of highway. Calculate the net volume of earthworks needed or available over the portion of the highway.

  Determine the specified dead loading for one interior

In the absence of motion, gravity, surface tension, electricity, and magnetism, the state of a pure substance is fixed by fixing at least:

  A small portion was removed and a moisture content test

An undisturbed cylindrical soil sample is 2.4 in. in diameter and 6 in. long. It has a weight of 1.95 lb. After finding the weight of the entire sample, a small portion was removed and a moisture content test was performed on it. The results of this ..

  Compute the value of the objective function and decision

Solve the following LP using the graphical method (graph sheets attached). Compute the value of the objective function and decision variables at optimality, and indicate which statement best describes the solution.

  What would be the concentration of pollutant leaving lagoon

A lagoon with volume 1200 m3 has been receiving a steady flow of a conservative waste at a rate of 100 m3/day for a long enough time to assume that steady-state conditions apply.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd