### Describe which would include a viable by-sell agreement

Assignment Help Civil Engineering
##### Reference no: EM13318139

Hardly Able Contracting Co., Inc., Contractors and Engineers, has been in business for twenty five years and has been progressively expanding since the firm's inception. Each of the three partners realizes that in order for the firm to continue at the present rate of growth a realistic business continuation plan must be in place which would include a viable by-sell agreement between the shareholders. Discuss, in detail, the mechanism that your firm should put in place to make sure the wishes, on business continuity, of the three shareholders could become reality

### Write a Review

#### Determine shear stress in 25 by 50 cm rectangular section

Determine the shear stress in a 25 × 50 cm rectangular section if the shear force is 20 KN and torsional moment is 10 KN m at service loads. Assume M20 mix and 0.75% tension reinforcement at an effective cover of 50 mm.

#### What is the stationing of the pt on the same highway

A crest vertical vurve and a horizontal curve on the same highway have the same design speed. The equal-tangent vertical curve connects a +3% initial grade with a +1% final grade and has a PVC at 101+78 and a PVT at 106+72

#### Determine the maximum external pull of the four gears

Determine the maximum external pull, in each of the four gears, for a tractor with 23-hp, and a max speed of 3.6 mph in 1st gear and a efficiency of 92%. When it is operated over a haul road whose slope is +2.53%.

#### Explain how to determine the particles velocity at s

acceleration of a particle traveling along straight line is a=(1/5)s^(1/2), s is in m, if v=0, s=3 when t=0 determine the particles velocity at s=6

#### Determine what will be the max torque of a solid steel shaft

A solid steel shaft of circular cross section and diameter 6 inches in pure torsion under torque. If E=30x10^6 pse and max shear stress is 30 ksi, calculate the torque. If the shaft was hollow, with an innner diameter of 2 inches and outer diameter..

#### How to calculate the asphalt content by weight of mix

The VMA of a mixture is 15.0% and the air voids are 4.0%.If the aggregate has a specific gravity (bulk dry) of 2.700 g/cm3 and percent binder absorbed (by the mass of aggregate) is 0.5%, calculate the asphalt content by weight of mix.

#### Which is the more relevant length scale for the problem

A model of a high-rise offiice building at 1/500 scale is tested in a wind tunnel to estimate the pressures and forces on the full-scale structure. The wind-tunnel air speed is 20 m/s at (20 degrees C) and atmospheric pressure.

#### Sample of natural glacial-groundwater table

A sample of natural glacial till was taken from below the groundwater table. The water content was found to be 52%. Estimate the wet density, dry density, buoyant density, porosity and void ratio. Clearly state any necessary assumptions.

#### Determine the flow rate of the oil

Oil of a specific gravity of 0.75 is flowing through a 6-in pipe under a pressure of 15 psi. If the total energy relative to the datumplate is 8.0 ft below the center of the pipe is 58.6 ft, determine the flow rate of the oil.

#### Explain how to estimate the los at the corridor

An airport corridor is 30 ft wide. given a peak demand of 300 pedestrians per minute and an average walk speed of 3 ft/s, estimate the LOS at the corridor

#### What would be the estimated total annual dollar savings

what would be the estimated total annual dollar savings of a company with an annual direct labor payroll of 2,500,000 and a fixed overhead rate of 150 percent of direct labor , if the company initiated a methods and standards program

#### Explain how to evaluate the coefficient of performance

0.1 moles of an ideal gas contained in a piston-cylinder assembly undergoes the heat pump cycle shown below. The cycle operates counter-clockwise. Evaluate the coefficient of performance. 