Define a set of capacitors at various busses in the system

Assignment Help Electrical Engineering
Reference no: EM13967733

1. If there are any problems with the bus voltages under typical daytime loads, propose a solution for this problem. Define a set of capacitors at various busses in the system to compensate for out-of-tolerance voltage variations.

2. What happens to the bus voltages under nighttime conditions of the capacitors proposed in Problem 1 are left attached to the system at night? Is it ok to permanently connect the capacitors to the power system, or must they be switched?

3. Suppose that the power system is operating under typical daytime loads, and the transmission line between Bus 4 and Bus 5 open circuits. What happens to the voltages on each bus now? Are any of the transmission lines overloaded?

Reference no: EM13967733

Questions Cloud

Identify important issue that is represented within article : The goal of this assignment is to identify the important issue that is represented within the article you select. Your task will be to share why this is an important and current issue in business and/or management.
Determine the daytime and nighttime voltages at every bus : Suppose that a new transmission line is to be added to the power system between Bus 1 and Bus 4. The line is rated at 200 MVA, and its series impedance is 0.008 + j0.064 pu. Assume that no capacitors have been added to the system, and determine t..
Calculate the heritability of religiousness : If the researcher uses Falconer's formula to calculate the heritability of religiousness without taking assortative mating into consideration, how would the heritability estimate be affected? (Would it be inflated? Deflated? Would it be accurate?)
Healthcare professionals often work rotating shifts : Healthcare professionals often work rotating shifts. In your own words, why is this problematic? What are the psychological, social, and physiological challenges related to rotating shifts? Consider sleep deprivation, high levels of stress, or side e..
Define a set of capacitors at various busses in the system : Suppose that the power system is operating under typical daytime loads, and the transmission line between Bus 4 and Bus 5 open circuits. What happens to the voltages on each bus now? Are any of the transmission lines overloaded?
New minimum cycle time : Because two of the process steps can now run in parallel (gathering the food and taking the money), what is the new minimum cycle time? What is the longest cycle time? What potential problems could arise by splitting the process across two individ..
What are some of the potential measures a nation can : What are some of the potential measures a nation can take if they believe an imported product is unsafe?
From mechanical engineering : From mechanical engineering solve the question below as shown in the image.
When and why did our ancestors come to america : Do we have any family heirlooms? Where did they come from? Do you have any valued or cherished objects? Why so you treasure that object? Who would you want to have it and why?

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Determine what is the maximum number of carrier frequencies

what is the maximum number of carrier frequencies that would ever be needed so that any arbitrarily partitioned region would never have two adjoining cells that use the same frequency

  Find average power loss in line before and after load added

The power factor of the added load is to be adjusted so that the overall power factor of the factory is 0.96 lagging. The factory is fed from a line having an impedance of 0.02 + j0.16 O. The voltage at the factory is maintained at 480 V(rms).

  Find the shaft speed nm for full-load conditions

A 50-kW 440-V 50-Hz two-pole induction motor has a slip of 6 percent when operating at full-load conditions. At full-load conditions, the friction and windage losses are 520 W, and the core losses are 500W. Find the shaft speed nm for full-load ..

  At what load resistance is maximum power delivered to load

A battery is limited in the amount of current that it can supply to a load. When disconnected and fully charged, the voltage across the battery terminals is measured to be 13.8 V. When connected to a load that dissipates 18 W of power

  What is the current flow of a circuit containing inductance

(A) What is the current flow of a circuit containing inductances of 1-H and 2-H connected in series to a 440 V 60 Hz source (B) What would the total circuit current flow be if the same two coils were connected in parallel to the voltage source

  Write program to subtract 32 from fahrenheit temperature

Write a main program to call a procedure that converts the Fahrenheit temperature value stored in the location labeled TdegF to its Celsius equivalent. The range of temperatures is 32°F to 212°F. The procedure stores the converted temperature

  Describe outlet switched from two switch locations

A duplex receptacle with one receptacle outlet always hot and the other outlet switched from two switch locations. The receptacle has two controlled outlets, must be powered through a switch control (SPDT), include all phase, neutral and grounding..

  Determine what is the frequency of oscillation

For a Wien-bridge oscillator Given R = 20Kohm and C = 10nF what is the frequency of oscillation Given a required frequency of oscillation of f = 3kHz and R = 5kohm, what should the value of C be

  Find two renewable energy application for converters

Find two renewable energy application where ac/dc converters are used. Explain qualitatively the role of the converter in the application

  What are the ideal and minimum possible temperatures

A temperature transmitter has an input range of 0 to 100 degrees celsius, an output range of 4 to 20 mA, and anaccuracy of ± 0.5%. The ideal transmitter has a linear output from 4 mA at 0 degrees celsius to 20 mA at 100 degrees celsius.

  Identify type of the circuit

1. Identify type of the circuit; Mealy or Moore 2. Derive the state table

  Determine what is the net electric flux through the surface

A point charge of 1.8mC is at the centre of a cubical Gaussain surface having each side 50cm. What is the net electric flux through the surface

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd