Condensed to a saturated liquid in a piston-cylinder device

Assignment Help Mechanical Engineering

Reference no: EM13712207

Maturated water vapor at 800 kPa is isothermally condensed to a saturated liquid in a piston-cylinder device.

(a) Calculate the amount of heat transferred during this process.

(b) Calculate the amount of work done (either in or out) during this process.

Reference no: EM13712207

Questions Cloud

Total amount of heat to be removed from the water : There is a process in which ball bearings made of plain carbon steel are rolling from an oven at a uniform temp of 870 degrees Celsius into a water bath where the water is at 37 degrees Celsius to quench them. A rubber conveyer belt then carries them..

Explain change in magnetic properties when steel is heated : Explain the change in magnetic properties when steel is heated. Is this due to allotropic properties?

Gravity is just the ratio of density of a material to water : A fan jumps into a swimming pool in an attempt to drown her sorrows. She is able to float on her back...in a position that is neutrally buoyant...so that she can continue to breathe through her mouth. Believing that 70% of her body is composed of wat..

Contained is a gas-tight frictionless piston-cylinder : A mass of 2.2 kg of helium at 381 kPa and -253oC is contained is a gas-tight frictionless piston-cylinder. The gas is expanded to a final pressure of 74 kPa in a poly tropic process where n = 1.667. Compute the work done (output positive) in the proc..

Condensed to a saturated liquid in a piston-cylinder device : Maturated water vapor at 800 kPa is isothermally condensed to a saturated liquid in a piston-cylinder device. Calculate the amount of heat transferred during this process.

Calculate the diffusion coefficient if the diffusion flux : A sheet of BCC iron 1.7-mm thick was exposed to a carburizing atmosphere on one side and a decarburizing atmosphere on the other side at 725°C. After having reached steady state, the iron was quickly cooled to room temperature. The carbon concentrati..

Calculate the mass-flow rate : The truncated nozzle shown in the figure below is used to monitor the mass-flow rate of air in a pipe. The area of the nozzle is 3 cm2. The total pressure and total temperature measured upstream of the nozzle in the pipe are 300kPa absolute and 20°C.

The tensional force of the string is in position : The 2 kg ball is releast from rest in position 1 with the string horizontal. The length of the string is L =2m and theta 40 degree. The ball's velocity when it is in position 2? The tensional force of the string is in position 2?

What should be the minimum horsepower of the lathe : A 3 in. diameter low strength, stainless steel cylindrical part is to be turned on a lathe at six hundred rpm. With a depth of cut of .3 inches and a feed of .025 in/rev. what should be the minimum horsepower of the lathe?

User Account

All Pages