Compute the ph and concentration of all species

Assignment Help Chemistry
Reference no: EM13227810

For a solution of acetic acid in water prepared from 0.50 moles of acetic acid dissolved up to a total volume of 1.0 L, (a) calculate the pH and concentration of all species present assuming that the activity coefficients are equal to 1.0 for all species

Reference no: EM13227810

Questions Cloud

What is the duration of the photocurrent if absorption occur : A Si PIN photodiode has an i-Si layer of width 20 µm. The p+ layer on the illumination side is very thin (0.1µm). The PIN is reverse biased by a voltage of 100 V and then illuminated with a very short optical pulse of wavelength 900 nm.
Compute the ph and concentration of all species : calculate the pH and concentration of all species present assuming that the activity coefficients are equal to 1.0 for all species
How many pounds of pepperoni would you order : Assume that the sales representative just walked in the door and there are currently 440 pounds of pepperoni in the walk-in cooler. How many pounds of pepperoni would you order?
How did you stimulate recall of prior knowledge : How did you stimulate recall of prior knowledge? What else might you have considered using and what two instructional delivery methods did you utilize? What else might you have considered using?
Compute the ph and concentration of all species : calculate the pH and concentration of all species present assuming that the activity coefficients are equal to 1.0 for all species
how many clerks and typists should be hired : how many clerks and typists should be hired assuming a 80 percent target utilization rate?
Explain deduced from the presence of the decay products : A rock is found to contain 83.7% of the amount of uranium-238 that it contained when it was formed. (The amount that the rock contained when it was formed can be deduced from the presence of the decay products of u-238 .) How old is the rock?
Calculate the essential bandwidth using energy percentage : a. Plot the spectra of X(w) = t sinc(wt/2). Let t = 1 and -20 =
What is the maximum revenue with a single shift : Using Equation 2.1 d. What is the maximum revenue with a single shift? e. What is the break-even volume with a two-shift operation?

Reviews

Write a Review

Chemistry Questions & Answers

  Calculate the concentration of oh- ion remaining in solution

A solution is made by mixing 15.5 g of NaOH and 73.0 mL of 0.150 M HNO3. Calculate the concentration of OH- ion remaining in solution.

  Explain what will be the mole of gas at 15 degree celcius

A gas measures 10ml at 27degree celcius and 750mm of mercury what will be the mole of gas at 15degree celcius and 750mm of mercury

  Compute the q for the water in joules

Calculate the Q for the water in Joules (c for water is 4.184J/g degrees celsius). Determine the Q for the metal in Joules based on your knowledge of conservation of energy. (you cannot use the Q=mcdeltaT equation, because you do not know the c fo..

  What is the mass of the column

a column of air with a pressure of 1.57 x 105 Pa and an area of 1.07 m2 and given that the acceleration due to gravity is 9.8 m/s2, what is the mass of the column.

  Define the solution of riboflavin from a stock solution

Determine how you would make a 100ppb solution of riboflavin from a 50mg/L stock solution. Do the same for preparation of a 500ppb solution from a 50mg/L stock solution

  Explain activation energies of the two mechanisms

When the ln( kE2 / kE1 ) is plotted vs. 1/T the resulting linear graph has the slope of - 4.8 and intercept of 6.1What is the difference in activation energies of the two mechanisms? For which mechanism are the reactive collisions more efficient?

  Ideally what should the ratio between the three slopes

Ideally what should the ratio between the three slopes (AlCl3 slope= 483.0 , CaCl2 slope= 421.4, and NaCl slope= 181.9) be? What are your actual experimental ratios?

  Explain what type of phosphate component

Since phosphate ionization of 2.14, 6.86 and 12.4. you make stock buffer 500mM in 1L. You decide to make one stock pH 6.5 and the other ph 7.2 How many mmols of what type of phosphate componet do you add to each of these buffers?

  What are mole fraction of methanol in this solution

A 2.9 m solution of methanol (CH3OH) in water has a density of 0.984 g/ml. What are the a) mass percent, b) molarity, and c) mole fraction of methanol in this solution?

  Describe volumetric flasks

Assuming that the appropriate volumetric flasks are available, describe how we would make these solutions: (a)175 mL of a 1.14 M solution of NH4Br in water (b)1.35 L of a 0.825 M solution of NaI in water

  Define the bond dipoles of iodomethane

Write a brief discussion of the bond dipoles of iodomethane and the corresponding Grignard reagent.

  Compute the mole fraction of oxygen

A mixture of gases conssists of CH4 at a partial pressure of 143 mm Hg, N2 at a partial pressure of 469 mm Hg, and O2 at a partial pressure of 563 mm Hg

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd