Compute the full-load speed

Assignment Help Chemical Engineering
Reference no: EM131113258

A 10-hp, 250-V shunt motor has an armature circuit resistance of 0.5 Ω and a field resistance of 200 Ω. At no load, rated voltage, and 1200 r/min, the armature current is 3 A. At full load and rated voltage, the line current is 40 A, and the flux is 5% less than its no-load value because of armature reaction. Compute the full-load speed.

Reference no: EM131113258

Questions Cloud

What could be the main causes for these surpluses : In contrast to the United States, Japan has realized continuous current account surpluses. What could be the main causes for these surpluses? Is it desirable to have continuous current account surpluses?
The balance consists of the following : The balance consists of the following. Illustrate how the information above should be shown on the balance sheet of Patriot Company onDecember 31,2010.
Calculate the number of moles of gas added to the container : A flexible container at an initial volume of 8.15 L contains 9.51 mol of gas. More gas is then added to the container until it reaches a final volume of 15.1 L. Assuming the pressure and temperature of the gas remain constant, calculate the number of..
How did these changes affect the sensitivity of the network : Identify the resources and the activities that are over-allocated through the Resource Usage view by scrolling horizontally. Make a note of the activities.
Compute the full-load speed : At full load and rated voltage, the line current is 40 A, and the flux is 5% less than its no-load value because of armature reaction. Compute the full-load speed.
Pseudocode on the examples : A brief description of the task. The pseudocode associated with the task. Base the pseudocode on the examples provided in Chs. 4, 5, and 6 of Prelude to Programming.
Find the speed of the motor : If the machine is run as a motor while absorbing 10 kW from 230- V mains, find the speed of the motor. Neglect the brush-contact drop.
Write one ordered pair : 1. Write one ordered pair that is in the set AxB but is not in the set BxA., or explain why no such ordered pair exists. 2. Write one ordered pair that is in the set BxA but is not in the set AxB, or explain why no such ordered pair exists.
Write the code to allow user to input three integer numbers : Write the code to allow a user to input three integer numbers. The program will then produce the average of thosethree numbers

Reviews

Write a Review

Chemical Engineering Questions & Answers

  Express the maximum radius and maximum thickness

Express the maximum radius (Rmax) and maximum thickness (Tmax) in terms of bulk oxygen concentration, Cb (mol/mL), diffusivity of oxygen through the device D (cm2/s) and maximum oxygen consumption rate, Vmax (mol/mL/s).

  Release of a radioactive nuclide

Which do you think would be the greater health hazard: the release of a radioactive nuclide of Sr or a radioactive nuclide of Xe into the environment? Assume the amount of radioactivity is the same in each case.

  Calculate the mass of the sample of silver

Calculate the energy required to raise the temperature of 1.0 mol Ag by 1.0C (called the molar heat capacity of silver). c. It takes 1.25 kJ of energy to heat a sample of pure silver from 12.0C to 15.2C. Calculate the mass of the sample of silv..

  Calculate masses of alcohol and ether

Assuming that there are no other significant side reactions, calculate masses of alcohol and ether produced, per 1000 kg of allyl chloride fed to the reactor.

  Approximate as an equilibrium triangular duct

HEAT TRANSFER PROBLEM NO18 - The configuration of a furnace can be approximate as an equilibrium triangular duct which is usually long enough so that the end effects are negligible , the hot wall is maintained at 900 k and has an emissivity e1 = 0..

  Materials of construction for the shell and tubes

The gases enter the condenser at 230 °C and leave at 50 °C. The cooling water enters the tubes at 20 °C and leaves at 50 °C. Suggest suitable materials of construction for the shell and the tubes.

  Determine the installed cost tube length and number of tube

All other conditions are the same as those specified in Example 5 of this chapter, except that Bi is not given. 8. Present a detailed derivation of Eq. (481 in this chapter, using, as a starting point, any of the other equations that are given.

  What is the fraction recovery of the enzyme

Assume negligible miscibility between the aqueous and organic liquids in each other, and ignore any change in density on removal or addition of the enzyme to either stream.

  Calculate the maximum mole% of co in the room

A 30.0 liter cylinder of a gas containing 97.0 mole% CO and 3.0% CO2 is delivered to your plant. The gauge on the tank reads 2000 psi. Several days later, the gauge reads 1875 psi, indicating a leak. The storage room in which the cylinder is kept has..

  Calculate the theoretical stages needed to separate

Calculate the theoretical stages needed to separate a 10 mole% ethanol liquid saturated feed into a 80 mole% distillate and a 0.1 mole% bottoms at 1 atmosphere pressure.

  Part-1why fiuids are importantnbspin chemical engineering1

part-1why fiuids are importantnbspin chemical engineering1. enormous number of materials normally exist fias gases or

  Define operation of a modern telephone handset

Operation of a modern telephone handset, In a modern telephone handset, the microphone uses a piezo-electric crystal and the earpiece is a miniature loud speaker using a moving coil and a permanent magnet.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd