Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
a .65% Carbon hypoeutectoid plain carbon steel is slowly cooled from 950 degrees C to just slighty above 723 degrees C calculate the weight percent austenite and weight proeutectoid ferrite in this steel
Perform a material balance on substrate (S) around a chemostat (completely mixed reactor without recycle) assuming a first-order removal for a substrate with a rate constant of 0.5 hr-1.
an insulated tank is evacuated. Air from the atmosphere at 12 psia and 70 degrees farenheight is allowed to flow into the 100 cubic foot tank. What is the final temp and the final mass of air in the tank just after flow ceases.
The tape is stretched over three equal spans. Calculate the tape corrections under the following conditions at field, temperature = 85ºF, pull = 18kg, E= 2.109 x 10 6 kg/cm 2
The maximum vertical load and horizontal load have been identified and shown in the figure. Under this loading condition, you are asked to determine the horizontal deflection of joint C.
A particle moves along the positive x-axis with an acceleration in meters per second squared which increases linearly with x expressed in millimeters, as shown on the graph for an interval of its motion.
A stainless steel tube with an outside diameter of 65 mm and a wall thickness of 5 mm is used as a compression member. If the axial normal stress in the member must be limited to 180 MPa, determine the maximum load P that the member can support.
A brass alloy has a yield strength of 280 MPa, a tensile strength of 390 MPa, and an elastic modulus of 105 GPa. A cylindrical specimen of this alloy 12.7 mm in diameter and 250 mm long is stressed in tension and found to elongate 7.6 mm.
The "Shape Factor" of a cross-section of a beam is defined as the fully plastic strength divided by the force or moment causing first yield. Thus the Shape Factor for bending is Mp/My and similarly for shear, is Vp/Vy.
horizontal pipe, and the fanning friction factor is f_F = 0.0060. what error in the pressure drop would ensue if the assumption were made that the flow was laminar, abandoning the previous value of the friction factor.
Steam enters a turbine with neglible velocity at 4 mpa, 600 degrees celcius and a flow rate of 36000 kg/h. Determine the heat loss from the steam passing through the turbine if the turbine has a power output of 20000 kw
The belt starts from rest at time t=0 and its speed increases at a constant rate of 150mm/s^2. Knowing that the coefficient of static friction between the pacakges..
Nitrogen is compressed from 80 kPa and 27?C to 480 kPa by a 10-kW compressor. Determine the mass flow rate of nitrogen through the compressor, assuming the compression process to be (a) isentropic
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd