Calculate the moles of argon present

Assignment Help Chemistry
Reference no: EM13145908

A 355 m-L container holds .146 g of Ne and an unknown amount of Ar at 35 degrees C and a total pressure of 626 mmHg. Calculate the moles of Ar present.

Reference no: EM13145908

Questions Cloud

Calculate the solubility product ksp for nis : A saturated solution of nickel(II) sulfide contains approximately 3.6 multiplied by 10-4 g of dissolved NiS per liter at 20°C. Calculate the solubility product Ksp for NiS at 20°C.
Compute the probability of a successful operation : Compute the probability of a successful operation (i.e., an operation in which at least one hit is a success) if all 3 missiles are launched and a hit within 40 miles of the target is considered a success.
Calculate the density of hydrogen bromide gas : Calculate the density of hydrogen bromide gas (in g/L) at 733 mm Hg and 47 degrees Celsius
Determine if reason for component failures is independent : Use an appropriate test to determine if the reason for component failures is independent of their designs. Show your manual calculations here.
Calculate the moles of argon present : A 355 m-L container holds .146 g of Ne and an unknown amount of Ar at 35 degrees C and a total pressure of 626 mmHg. Calculate the moles of Ar present.
Define what are the molar enthalpy and total enthalpy : What are the molar enthalpy and total enthalpy of the pure system when 50% and 75% have been evaporated at: (i) 30°C, (ii) 50°C? Use liquid at 25°C as a reference state
Explain why an observed value of hours is not unusual : Explain why an observed value of 250 hours is not unusual for an individual light bulb, even though it is outside the confidence interval you calculated.
Products using the relative sales value to split off : Allocate joint costs to the two products using the relative sales value to split off as the allocation basis.
Explain the transfer of energy and bioaccumulation : Explain the transfer of energy and bioaccumulation through primary , secondary, tertiary, and quaternary trophic levels. You may answer this part of the question by drawing a diagram and using arrows where applicable .

Reviews

Write a Review

Chemistry Questions & Answers

  What is the solubility product constant

What is the solubility product constant? Given Ksp = 1.1 x 10^-3 for BaF2(s), calculate the molarity of Ba+2 in a saturate solution of BaF2 (at equilibrium).

  Determining osha permissible exposure limits

Suppose that the solvent ethanol could serve to replace the methanol in this process, but at the expense of double the concentrations of the solvent in the atmosphere.

  What mass of magnesium chloride is needed

What mass of magnesium chloride is needed to react with 145 g of silber nitrate accourding to the following reaction: MgCl2(aq)+2AgNO3(aq) -> Mg(NO3)2(aq) + 2AgCl

  Determine the final temperature of the mixture

A student has sample of HNO3 of 340 ml at 25 degrees celsius and add water of 110 ml at 95 degrees celsius then determine the final temperature of the mixture

  Determine what is the final volume the gas

Determine what is the final volume the gas occupies If the pressure of a gas inside the cylinder changes from 840.0 mmHg to 360.0 mmHg,?

  What is the average speed of a co2 molecule

If the average speed of an oxygen molecule is 4.05multiplied by 104 cm/s at 25°C, what is the average speed of a CO2 molecule at the same temperature?

  Determine the dh solution

Determine the ΔH solution for this compound If the heat of solvation for this compound = -30.8 kJ/mol , crystal lattice energy = -62.2 kJ/mol.

  What volume would it occupy

If the methane contained in 4.00 L of a saturated solution at 25 C was extracted and placed under STP conditions, what volume would it occupy?

  Determine the molar concentration of silver nitrate

Determine the molar concentration of silver nitrate(AgNO3) in a solution if titration of twenty five mili litres of the solution with 0.300M sodium chloride (NaCl) needs 37.05ml of the sodium chloride solution to reach the end point?

  What is the concentration of the total available acid

a student titrates 50.0ml of apple juice and reports the following in the titration to the phenolphthalein end point with 0.1011 M NaOH.

  Calculate the ph of this buffer solution after the addition

Calculate the pH of this buffer solution after the addition of 0.010 moles of solid sodium hydroxide to the buffer

  Calculate percent h2so4 in the original acid solution

4.00g of H2SO4 solution was diluted with H2O and added with excess of cacl2, and The washed and dried precipitate of BaSO4 weighted 4.08g. Calculate percent H2SO4 in the original acid solution.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd