Calculate the final pressure temperature when the nitrogen

Assignment Help Civil Engineering
Reference no: EM13529923

One cubic meter of Nitrogen at 40 C and 340 kPa is compressedisentropicly to 0.2 cubic meters.

Calculate the final pressure, temperature when the nitrogen isreduced to that volume. What is the modulus of elssticity at thebeginning and end of the compression. k=1.4

Reference no: EM13529923

Questions Cloud

What torque is required to drive the disk : A 2.25 Adisk spins within an oil-filled enclosure,having 2.4-mm clearance from flatsurfaces each side of the disk. The disk surface extends from radius 12 to 86 mm.What torque is required to drive the disk at 660 rpm if the oil's absoluteviscosity is..
Find the magnitude of the force on one side of the plate and : A rectangular plata 5 ft by 4 ft is at an angle of 30 degrees with the horizontal, and the 5-ft side is horizontal. Find the magnitude of the force on one side of the plate and the depth of its center of pressure when the top edge is 1 ft below the w..
What is the density : A valueable preserved biological specimen is weighed by suspeding it from a spring scale. it weighs 0.45 N when it is suspendedin air and 0.081 N when it is suspended in a bottle of alchol what is its dencity?
Estimate the minimum absolute pressure : When a fluid flows through a sharp bend, low pressures may developin localized regions of the bend. Estimate the minimumabsolute pressure (in psi) that can develop without causingcavitation if the fluid is water at 160 oF.
Calculate the final pressure temperature when the nitrogen : Calculate the final pressure, temperature when the nitrogen isreduced to that volume. What is the modulus of elssticity at thebeginning and end of the compression. k=1.4
The magnitude of the unit vector of bxa : For Vectors A=(i + 2j - 3k) and B=(4i - 5j + 6k), determine:
What are the force and total time required : What is the weight of a 10-ft3 tank of oxygen if the oxygen is pressurized to 400 psia, the tank itself weighs 100 lbf, and thetemperature is 700F?
What is the modulus of elasticity at the beginning and end : One cubic meter of nitrogen at40oC and 340 kPa iscompressed isoentropically to 0.2 m3. Calculate the finalpressure and temperature when the nitrogen is reduced to that volume.
What force is necessary to lift a thin 25-mm diameter ring : What force is necessary to lift a thin 25-mm diameter ring out of :

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine the transmissivity through a confined aquifer

A 12-in well is drilled through a confined aquifer of average thickness 80 ft. Two observation wells located 50 and 120 ft away register a difference in drawdown of 10 ft. The steady-state pumping rate is 1000 gpm

  Compute the coefficient of roughness with a bottom width

A trapezoidal canal with a bottom width of 2 m, a side slope Z=1.5, and a longitudinal slope of 0.0006 conveys a flow rate of 3 m^3/s. If the water depth in section 1 is 0.78 m and in section 2

  Determine the magnitude and direction of the resultant force

determine the magnitude of the resultant force and its direction, measured counterclockwise from the positive axis. The other force is F=700N with a 15 degree angle to the x-axis.

  Determine the total crop water requirement

Determine the total crop water requirement including the leaching ratio of a corn crop with a ECt of 1.7mmhos cm-1 if the ECiw of the irrigation water and precipitation is 5 and 0 mmhos cm-1 respectively

  What will be the impact on fish population in the stream

Below a discharge from a wasterwater treament plant , an 8.6km stream has a reoxygenation constant of .4 d^-1, a velocity of .15m/s, a dissolved oxygen concentration of 6mg/L, and an ultimate demand of 25mg/L.

  Find what would be the concentration expressed in ppm

If the quantity of ash released from the power plant each minute were to be eventually despersed in 4,000,000 m^3 of air at 25 degrees Celsius and 1 atm, what would be its concentration expressed in ppm

  Determine whether the discharge of the towns wastewater

The Big Bear town council has asked that you determine whether the discharge of the town's wastewater into the Salmon River will reduce the DO below the state standard of 5.00 mg/L at Little Bear, 5.79 km downstream.

  Determine the force developed in the link

The coefficients of kinetic friction between the blocks and the inclined plane are a=0.1,b=0.3. Neglect the mass of the link. Angle between the inclined plane and the surface is 30 degree.

  Determine what will be the hydraulic conductivity of the gcl

If this GCL is used as a liner beneath a 55-ft high landfill with a waste unit weight of 45 lb/ft3, what will be the hydraulic conductivity of the GCL at the bottom of the landfill

  Determine the maximum power output of the pelton wheel

A Pelton wheel, located at an elevation of 200.0 m, is used to extract power from a reservoir at an elevation of 800 m. A penstock 1500 m long and 0.8 m in diameter connects the reservoir with the nozzle of the Pelton wheel.

  Draw to scale the expected streakline of the stream

The following wind conditions are expected: V = 10 i - 5 j mph for 0 10 hr. Draw to scale the expected streakline of the stream  for t = 3, 10, and 15 hr.

  How many square inches of coating need to be applied

Workers plan to apply a reflective coating of paint to one surface of an equilateral triangular shaped highway sign. How many square inches of coating need to be applied to the sign if one side of the triangle is 12 inches

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd