Calculate the critical radius and the number of atoms

Assignment Help Civil Engineering
Reference no: EM13560407

1.Calculate the critical radius and the number of atoms in the nucleus of the homogeneous nucleation in GERMANIUM. The latent heat of fusion is 8100 cal per g-mile (atom) and the coefficient of linear expansion is 5.75*10^-6 per K

2.If the nuclei from the liquid were cuboids, determine the critical radius and the activation energy of solidification for Spheroidal nuclei.

3.Determine the water level rise in an unconfined aquifer produced by a seasonal precipitation of four inches. The aquifers porosity is 20 percent and its specific retention is 9 percent.

Sr=wr/ Vt = 9%; a = Sr + Sy =20%; Sy =11%

Reference no: EM13560407

Questions Cloud

What is the maximum population that can be served : What is the maximum population that can be served by a 900 mm diameter main sewer constructed on minimum grade? If sewage flow in the pipe never exceeds a depth of 600 mm, estimate the actual population contributing flow to the main.
What is the net force of the water on the block : A horizontal het of water at 5 degrees celsius strikes a block and is deflected upward 30 degrees. The mass flow rate of the water is 1.75 kg/s. The mass of the block is 1.30 kg. The jet has a cross sectional area of 10 cm^2
Explain senior management role : Explain senior management's role in preparing the organization to shift from a catalog-based retailer to an Internet retailer. Provide evidence of whether the transition was seamless or problematic from a management perspective. Provide support for y..
Ensure the application of the concepts and techniques learnt : Prepare the Outline of the Final Project based on your approved Project Proposal submitted in Week 4. The Outline must be structured on the Proposal to ensure the application of the concepts and techniques learnt in this module.
Calculate the critical radius and the number of atoms : Calculate the critical radius and the number of atoms in the nucleus of the homogeneous nucleation in GERMANIUM. The latent heat of fusion is 8100 cal per g-mile (atom) and the coefficient of linear expansion is 5.75*10^-6 per K
Basic case analysis assignment : Basic Case Analysis Assignment
Determine the hydraulic conductivity of the soil sample : A constant head permeameter has a sediment sample with a cross sectional area of 100 cm^2. The sediment sample is 30 cm long. The porous plates on top and bottom of the sample holding it in place have a vertical hydraulic conductivity of 0.001 cm/s a..
Medical devices sold in japan : Medical devices sold in Japan
What flow rate of fresh water (in m3/s) must they use to red : mg/L of salt. The new owners propose to flush the pond into their discharge pipe leading to the Atlantic Ocean, which has a salt concentration above 30,000 mg/L.

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine the cohesion and the angle of friction of the soil

Undrained shear box tests were carried out on a series of soil specimens with the following results:Total normal stress (kPa) Total shear stress at failure (kPa)

  Calculate the diameter of therope needed to support the load

A load of 14 tonnes is suspended at the end of a steel rope.If the load is subjected to a maximum acceleration/deceleration of2.5m/s2, when raised and lowered, calculate the diameter of therope needed to support the load.

  Determine maximum concentration of chlorides to be observed

A non-reactive chloride solution is continuously discharged into an aquifer. The concentration at the discharge location is 800 mg/L. Determine the maximum concentration of chlorides to be observed at an observation well 30 m downstream of the disc..

  What fraction of the flue gas stream would need to be bypass

The company engineer decides that this is too good, that it is not necessary to be this efficient, and proposed that part of the flue gas be bypassed around the electrostatic precipitator so that the recovery of fly ash (particulates) from the flu..

  Calculate the bod loading and days of winter storage

Calculate the BOD loading and days of winter storage available between the 0.6 and 1.5 m depths, assuming a daily water loss of 0.30 cm by evaporation and seepage.

  Determine the height of the weir for discharge coefficient

This weir is to be replaced by an uncontracted horizontal weir that will maintain the same upstream depth. Determine the height of the weir if the discharge coefficient is based on the following equation: C = 1.78 * 0.22(H/p)

  Determine the temperature t and the specific volume

A turbine expands to a pressure of 10 kPa and a quality of 0.94. Determine the temperature T and the specific volume at this state.

  Ignore emissions from manufacturing the packaging

Ignore emissions from manufacturing the packaging material

  Write mass balance equation for an ideal 1d plug-flow stream

Assume the rate constant for BOD decay is 0.2 d^-1, the mean velocity of the stream is 0.5 m s^-1, and the initial concentration is 100 mg L^-1 at x=0. Plot the resulting concentration with downstream distance x in km.

  What would be the capillary pressure between oil and water

If the interfacial tension between air-mercury interface in a capillary tube is 480 dynes/cm and the contact angle through the mercury is 140, what would be the capillary pressure between oil and water

  Determine the percentage increase in the discharge

As part of a drainage improvement project, a drainage ditch will be straightened and cleaned. As a result, the lenght of the ditch will decrease from 1800 ft to 1400 ft and the mannings roughness factor will be reduced

  Provide an equation that give an uncertainty of pressure

equation for pressure in bottom layer of a 2 layer fluid is: pressure,p =( specific weight of fluid 1,y1*thickness of fluid 1,h1) + ( specific weight of fluid 2,y2 * ( depth below the free surface at which the pressure is being determined, h - thi..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd