Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Water is transported from a reservoir at higher elevation to another reservoir through a series of three pipes. The first pipe of 400mm diameter is 500 m long, the second pipe 600 m long, size 300mm, and the last pipe is 500m long of diameter 200mm. If the elevation difference between two reservoirs is 30m, calculate equivalent pipe size and flow in the pipe.
Write out the continuity and momentum equations that govern the surge travelling downstream. (Note: assume that the surge velocity exceeds the water velocity)
A 6 inch X 4 inch rectangular beam is subjected to a maximum shear force of 1900 lbf. Determine the shear stresses at each of the following points on the beam cross section:
Two monitoring wells were constructed in an unconfined aquifer. The wells are separated by a distance of 250 ft. The water surface elevations in the up-gradient and down-gradient wells were 101.00 and 100.85 ft, respectively.
A 10-min experimental run shows that 75% of a reactant is converted to a product by a zero-order reaction rate. What would be the fraction converted in a half-hour run. Assume the reactor is a batch reactor.
At the same instant the frame h, not the horizontal blade, rotates about a vertical axis with a constant angular velocity w=0.9 rad/s, measured relative to h
A cast iron water main 14m long of 600 mm inside diameter and 30 mm wall thickness runs full of water and is supported at its ends. Calculate the maximum stress in the metal if density of cast iron is 7200 kg/m and that of water is 1000 kgm.
A W16 x 36 simply supported beam is 30 ft long and supports auniform dead load of 970 lb/ft, a roof live load of 240 lb/ft and asnow load of 270 lb/ft. Is this beam adequate to support the load? Please show the calculations.
A girder that carries a uniformly distributed dead load of 1.7 K/ft plus its self-weight and three concentrated live loads of 15 kips at quarter points of that 36 ft span is to be sized.
What is the shear rate in the water between a sliding and standing plate, if V = 10 ft/s is the moving plate velocity and 0.1 in. is the distance between the plates
When the 1.10 wt% C steel is cooled under equilibrium conditions from 925 (deg C), (i) what are the relative amounts of the primary or proeutectoid phase, the pearlite, and the total ferrite phase immediately below the eutectoid temperature
A submerged surface has an area of 25 square feet, and the resultant force acting on it is 100 pounds, what is the pressure exerted on the surface, in psi
Benzene is to be absorbed from coal gas by means of a wash oil. The inlet gas contains 3% by volume of benzene, and the exit gas should not contain more than 0.02% benzene by volume. The suggested oil circulation rate is 5 kg oil per 1m3 of inlet gas..
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd