Block of copper at at initial temperature

Assignment Help Mechanical Engineering

Reference no: EM13708157

A 25-kg block of copper at at initial temperature of 150 C equilibrates with 0.79 kg of liquid water at an initial temperature of 20 C in an insulated tank. If the average specific heat of copper can be taken to be 0.395 kJ/kg.K, determine the final temperature

Reference no: EM13708157

Questions Cloud

Maximum normal stress and the maximum shear stress : A thin walled tube with closed ends has an inside radius of 80mm and a wall thickness of 6 mm. It is subjected to an internal pressure of 20 MPa, a torque of 60 kN*m, and an axial compressive force of 200 kN. Determine the maximum normal stress and t..

Determine the volumetric flow rates at the inlet and exit : Refrigerant 22 enters an insulated compressor operating at steady state as saturated vapor at - 16 C with a mass flow rate of 1.5 kg/s. Refrigerant exits at 7 bar, 70 C. Changes in KE and PE from inlet to exit can be ignored. Determine: (a) the volum..

Calculate displacement-velocity-acceleration for assembly : A certain piston cylinder assembly has a stroke of 85mm, a connection rod length of 130 mm and a piston pin offset of 2mm. Calculate the displacement, velocity and acceleration of the assembly operating at 2200 RPM. If the same configuration is used ..

Drip irrigation problem : Drip irrigation is a means of getting water directly to growing plants with very little waste. One method uses a large-diameter polyethylene "mother" tube (10-15 mm i.d.) from which lead many small diameter polyethylene feeder tubes, called drippers,..

Block of copper at at initial temperature : A 25-kg block of copper at at initial temperature of 150 C equilibrates with 0.79 kg of liquid water at an initial temperature of 20 C in an insulated tank. If the average specific heat of copper can be taken to be 0.395 kJ/kg.K, determine the final ..

The raw material price and consumable price : Within the last month, the raw material price and consumable price combined has increased by 5.5%. If the throughput was 5 parts/hour estimates the future throughput that has to take place in order to maintain a constant production cost. Consider the..

Compressor is employed to compress gas : A compressor is employed to compress gas flowing steadily through it. The gas enters the compressor at a temperature of 16Â°C, a pressure of 100 kPa, and with an enthalpy of 391.2 kJ/kg. The gas leaves the compressor at a temperature of 245Â°C, a pre..

Buoyant device used for measuring specific weight of liquid : A hydrometer is a buoyant device used for measuring the specific weight of a liquid. A weighed glass bulb floats below the surface with a graduated stem extending above the surface. The position of the fluid level on the steam corresponds to the spec..

Determine the final pressure and the quality-boundary work : A piston-cylinder device initially contains 0.15-kg steam at 3.5 MPa, superheated by 5C. Now the steam loses heat to the surroundings and the piston moves down, hitting a set of stops at which point the cylinder contains saturated liquid water. The c..

User Account

All Pages