What is macro, Electrical Engineering

Assignment Help:

What is macro?

A macro is a group of instructions written within brackets  and recognized  by a name .This is used when a repeated group of instructions is too short or not appropriate to be written as a subroutine

 


Related Discussions:- What is macro

Construction - unijunction transistor, Construction - UniJunction Transisto...

Construction - UniJunction Transistor: Construction: The basic structure of uni junction transistor is shown in fig. (a). It essentially consists of a lightly doped N type s

Simulink help, I want simulink model for carrier based pwm method

I want simulink model for carrier based pwm method

How 8255 programmable peripheral interface can operate, What are the differ...

What are the different modes in which 8255 Programmable Peripheral Interface (PPI) can operate? Twenty Four I/O lines in 38-bit port groups - A, B and C A and B can be

How time slot interchange, Q. How time slot interchange switch works in tim...

Q. How time slot interchange switch works in time multiplexed time switching, Elucidate using schematic. Ans: Switches for which inlets and outlets are trunks that carry tim

Difference, Difference between bootstrip sweep circuit and Miller sweep ci...

Difference between bootstrip sweep circuit and Miller sweep circuit

Find the nature of the armature voltage, Q. The flux-density distribution p...

Q. The flux-density distribution produced in a two - pole synchronous generator by an acexcited field winding is B(θ, t) = B m sin ω 1 t cos θ Find the nature of the armatur

Write a short note on heat sink, Q. Write a short note on heat sink For...

Q. Write a short note on heat sink For transistors handling small signals ,the power dissipated at the collector is small.Such transistors have little chances of thermal runawa

Determine the resultant line current and power factor, Q. A three-phase loa...

Q. A three-phase load, connected to a 440-V bus, draws 120 kWat a power factor of 0.85 lagging. In parallel with this load is a three-phase capacitor bank that is rated 50 kVAR . D

Estimate hortons infiltration equation , Show that the infiltration volume ...

Show that the infiltration volume estimated using Horton's infiltration equation between times t1 and t2 is given by; F =f c (t 2 -t 1 )+(f 1 -f c )(1-e -k(t2-t1) )/k Use the

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd