chemical engineering, Other Engineering

A steel cylinder 10 cm in diameter and 10 cm long is initially at 300 0C. it is immersed in an oil bath which is maintained at 40 0C, with h= 280 W/m2. 0C. Find the temperature at the center of solid after 2 min.
Posted Date: 5/5/2012 6:22:38 AM | Location : United States







Related Discussions:- chemical engineering, Assignment Help, Ask Question on chemical engineering, Get Answer, Expert's Help, chemical engineering Discussions

Write discussion on chemical engineering
Your posts are moderated
Related Questions
Continuous Casting : In essential, the process consists of pouring molten metal into a short vertical metal die or mould (at a controlled rate), which is open at both ends, coolin

A type of brake used to keep the vehicle from rolling when it is parked. The standard Parking brake locks the rear wheels to keep the car from moving. Parking brake cable is fixed


How do comets get their tails? - Most comets stay frozen in the outer solar system. Only a few enter the inner solar system where they can grow tails. - When a comet nears the sun

The brayton cycle: The working cycle of the gas turbine engine is similar to that of the four-stroke piston engine.  There is induction, compression, ignition and exhaust in bo

Low pressure turbine clearance control valve: At take-off and low altitude the valve is in its normal closed position allowing cooling airflow to the core compartment. When an

determine the ash content in given sample

DEPLETION MODE MOSFET: In the depletion-mode type, charge carriers are present in the channel at "Zero" gate bias and the device is, therefore, conducting.  The application of

One thing I have always thought that experienced repair people knew about was circuit analysis. I always imagined that when looking at schematics I would be able to figure the vol

A 3.6-cm inside diameter stainless steel pipe is being used to convey a liquid food. The inside convective heat-transfer coefficient is 10 J/s.m2. o C. The pipe is 0.5 cm thick and