Switching characteristics - power semiconductor devices , Electrical Engineering

Switching Characteristics

Switching  characteristics are also know  as dynamic or transient characteristics these  characteristics give  the information  about the  time  variation with  different  voltage across  teh thyrisotr and time variation with  different  currents through  thyristor when  thyristor comes from  forwards  off state to on state  ( turn on period)  and from  on state to  forward  blocking  state ( turn off period)  the switching characteristics of SCR  are shown  in figure.


Posted Date: 4/2/2013 3:35:48 AM | Location : United States

Related Discussions:- Switching characteristics - power semiconductor devices , Assignment Help, Ask Question on Switching characteristics - power semiconductor devices , Get Answer, Expert's Help, Switching characteristics - power semiconductor devices Discussions

Write discussion on Switching characteristics - power semiconductor devices
Your posts are moderated
Related Questions
Electricity beyond doubt is very useful and essential for us; but if dealt with carelessly, it can prove to be very fatal. It is compulsory for a laboratory assistant to be sure of

The resistance of 1.5 km of wire of cross-sectional area 0.17 mm 2 is 150Ω. Determine the resistivity of the wire.

Determine power reflection coefficient at the input port: For the MESFET equivalent circuit shown below, find S 11 and S 22 . Note that resistances associated with the voltag

1) Draw the state diagram for the state machine described by Table 7.5 in the text. Note, the table shows the transition to the next state S* from the current state S for the next

Determine the form factor and peak factor: Determine the form factor and peak factor for the above half rectified wave. Solution From the above example, I rms   =

List four sources of information which are essential to the designer of this electrical installation.

Write a short explanation of the principles of super-heterodyne receiver. It may help to use sample block diagram to state the process. Why is the production of the intermediate fr

Q. Show the Decimal to Hex Conversion? To convert the decimal to the hex is slightly more difficult. The usual method to convert from decimal to hex is repeated division by 16.

In a certain chemical-processing plant, a liquid chemical is used in a manufacturing process. The chemical is stored in three different tanks. A level sensor in each tank produces

Q. Analog communication systems? An analog message is a continuum of possible amplitudes at any given time, and analog signals are continuous in time and in amplitude, such as