DC shunt generator, Electrical Engineering

Assignment Help:
in DC series generator we consider Eg=V+Ia(Ra+Rse).But in DC shunt generator why it is only Eg=V+IaRa and not Eg=V+Ia(Ra*Rsh/Ra+Rsh)

Related Discussions:- DC shunt generator

Find the flux density in the air gap of the right leg, Q. In the magnetic c...

Q. In the magnetic circuit shown in Figure the center leg has the same cross-sectional area as each of the outer legs. The coil has 400 turns. The permeability of iron may

Show the subtraction method, Q. Show the Subtraction Method? For this p...

Q. Show the Subtraction Method? For this procedure (method), start with a weighted position value greater that the number. If the number is greater than the weighted position f

Introduction to microprocessors , Normal 0 false false fals...

Normal 0 false false false EN-IN X-NONE X-NONE

Draw the power flow diagram showing voltages, For the 3 bus system shown be...

For the 3 bus system shown below all values are given in pu on a 100MVA base (a) Use Matlab functions lf gauss and lf Newton to find power flow solution for the system, accurate

Discuss description of insulating materials, Discuss description of insulat...

Discuss description of insulating materials on the basis of physical and chemical structure Insulating materials, on the basis of their physical and chemical structure may be d

How can a jfet be used as a constant current source, Q. How can a JFET be u...

Q. How can a JFET be used as a constant current source? Explain from the drain characteristics. As the VDS voltage is increased from 0 to a few volts, the current will increase

Lift interface circuitry, Draw the circuit diagram for  the  connections to...

Draw the circuit diagram for  the  connections to the EPROM and  just one RAM device  as defined  in  the memory map in question  3. You must show all the connections required to o

Determine the input current and input voltage, Q. A 100-kVA, 2300:230-V, 60...

Q. A 100-kVA, 2300:230-V, 60-Hz, single-phase transformer has the following parameters: R 1 = 0.30 , R 2 = 0.003 , RC 1 = 4.5k, X 1 = 0.65 , X 2 = 0.0065 , and Xm 1 = 1.

Resistance, if the sheet resistance of a tin oxide is 100 ohms, what is the...

if the sheet resistance of a tin oxide is 100 ohms, what is the thickness of the oxide layer?

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd