Standards and labelling - features of energy conservation, Electrical Engineering

Standards and Labelling - Features of Energy Conservation

Standards and Labelling (S & L) has been recognized as a key activity for improvement in energy efficiency. The S & L programme, while in place would ensure in which only energy efficient equipment and appliances would be made available to the consumers.

The major provisions of the Act on Standards and Labeling are to:

  1. Evolve minimum energy performance and consumption standards for notified equipment and appliances;
  2. Prohibit manufacture, sale or purchase or import of such equipment or appliance, which does not conform to the energy consumption standards;
  3. Introduce a mandatory labeling scheme for notified equipment appliances to enable consumers to make informed choices; and
  4. Disseminate information on the advantages of energy conservation and efficient energy use to consumers.

The equipments to be covered initially under the S&L programme are household refrigerators, air-conditioners, electric motors, water heaters, agriculture pump sets, electric lamps and fixtures, industrial fans and blowers, and air-compressors.

Posted Date: 2/1/2013 12:18:46 AM | Location : United States







Related Discussions:- Standards and labelling - features of energy conservation, Assignment Help, Ask Question on Standards and labelling - features of energy conservation, Get Answer, Expert's Help, Standards and labelling - features of energy conservation Discussions

Write discussion on Standards and labelling - features of energy conservation
Your posts are moderated
Related Questions
Single Phase Meters Single phase meters are commonly rated for 240 V AC supply; the current ratings are 5/10, 10/20, 2.5/10 or 5/20 A or are for direct connection to the mains

Q. What is Idss. What are the conditions for its maximum value? The term 'Idss' refers to saturation condition of the Drain current. From the above graph it's clear that as the

Explain the CMP instruction . CMP: The comparison instruction is a subtraction which changes only the flag bits; the destination operand certainly not changes. A comparison is h

Question 1: Planning is one of the primary functions of management. (a) Explain the importance of planning in an organisation. (b) How can managers develop an effective a

Property of material which allows it to be drawn out into wires is (A) Ductility.                                    (B) Solder ability. (C) Super conductivity.

Q. Write a brief note on common drain amplifier Since voltage at the gate-drain is more easily determined than that of the voltage at gate-source, the voltage source in the inp

Calculate the diameter of copper wire of length 100 metres used as winding material in a transformer such that the resistance of the whole winding is 2 ohms. Calculate the diameter

explain the alphanumeric codes

You should document each step of each iteration of your design. 1. You should include the following items from your preparation. a. A state diagram of the handshaking receive

What is TPA (transient program area)? The memory system is divided in three major parts: transient program area, System is and XMS that is extended memory system.