Solid Mensuration, Mechanical Engineering

How di i get the volume of a regular pentagon if the given was a height of 9", a base of 3" and a central angle of 75
Posted Date: 2/19/2013 7:56:53 AM | Location : Philippines







Related Discussions:- Solid Mensuration, Assignment Help, Ask Question on Solid Mensuration, Get Answer, Expert's Help, Solid Mensuration Discussions

Write discussion on Solid Mensuration
Your posts are moderated
Related Questions
The 70m microwave transmission tower is steadied by three guys cable. Cable AB carries a tension of 12kN. Express the corresponding force on point A as a vector

TERMINOLOG Y: 1 .     Top dead and Bottom dead Centre: These are 2 extreme positions between which the piston reciprocates inside the cylinder. TDC and BDC have relevance

Concept and application of limiting friction: Sol.: The maximum value of frictional force that comes into play, when the body just begins to slide over the surface of the ot

In order to get your first experience of ARM programming, this way you are familiar with the problem itself, its design, its flow of execution and you can use your own C code as ps

What is Plain Concrete Footing? Plain Concrete Footing: Footings carrying relatively light loads are constructed with plain concrete. You have already seen a plain concrete

ESSENTIAL S OF A GOOD BOILER: -     Should be capable of producing the required Steam at   the required pressure for minimum fuel required. -     Should be capable of stan

Describe the following terms:- a) Shear force and bending moment b) Concentrated load, Uniformly varying load and Uniformly distributed load c) Beam & Types of beam. d)

Nominal Strain and True Strain: Nominal Strain is ratio of change in length per initial length.  Nominal strain =  Change in length / Initial length = Δ L /   L

Q. What are the role of Roads in design of a plant? Roads are an important part of the design of a plant, as they provide access and separation during normal operation as well

how to fraw a parabolla in parallelogram