signals & systems, Electrical Engineering

transformation of independent variable e.g. time related explaination
Posted Date: 3/9/2013 8:21:01 AM | Location : Pakistan







Related Discussions:- signals & systems, Assignment Help, Ask Question on signals & systems, Get Answer, Expert's Help, signals & systems Discussions

Write discussion on signals & systems
Your posts are moderated
Related Questions
ADD Instruction Op code  format  of ADD instruction is Replace  the three bit code  of the register R from   to obtain the op code of the  required ADD instruction . op co


Disadvantage - High  level  Languages a.Computational time is more as compared to  machine languages. b.Requires more  memory. c.Requires the knowledge of specific rules

Change the brightness of the most beneficial illuminated LED to represent voltages among the ranges so that if the value is half way among the range then the LED should be 50% brig

Q. If a feeder circuit-breaker trips, what action is needed? Ans: First isolate the faulty feeder check the faulty area on which fault the breaker was tripped (open circuit,

First Generation (1946- 1654) In the  first  generation computer  vacuum tubes and valves were used. These computer were very large in size ( thousands of square feet on the fl

A bus is a collection of conducting lines that carrier's data, address, & control signals. A bus is two or many wire communication technique. A bus which communicate among two

Q. Input offset voltage of operational amplifier? When both inputs are tied to ground, i.e., both differential-mode and common-mode inputs are zero, the output should be zero.

SIM Set Interrupt Mask Instruction This  instruction is used  to mask unmask 8085 interrupts and send  serial  output  data. The accumulator  is used to load the  require data

Design 8:1 Mux for a given function, f=Σ (0, 1,5,7,9, 13)