What do you mean by most and least significant digits, Electrical Engineering

Assignment Help:

Q. What do you mean by Most and least significant digits?

The MSD (most significant digit) in a number is the digit which represents the largest part of the number. Therefore in the number 59382 the MSD is 5.

Similarly the LSD (least significant digit) is the digit which represents the smallest part of the number. Yet again, in 59382 the LSD is the 2.


Related Discussions:- What do you mean by most and least significant digits

Introduction to problem based learning, The Problem Based Learning is an ap...

The Problem Based Learning is an approach to learning prepares the students to engage with challenges similar to real world problems.The VEB3001-Problem Based Learning has been an

What are the signals used in input control signal, What are the signals use...

What are the signals used in input control signal & output control signal? Input control signal STB (Strobe input) IBF (Input buffer full) INTR(Interrupt request) Ou

Sparking with electrical equipment, Sparking : In ordinary domestic situat...

Sparking : In ordinary domestic situations, small electrical sparks are usually not hazardous. In certain conditions which are frequently encountered in science labs, even the sma

Why depletion mosfet is known as normally-on mosfet, Q. Why depletion MOSFE...

Q. Why depletion MOSFET is known as "normally-on MOSFET" ? Draw the symbol of n-type and p-type depletion MOSFET. In depletion type MOSFET the drain current flows even when VGS

Find the current flow through resistor using thevenin''s, Find the current ...

Find the current flow through resistor 12 Ω using Thevenin's Theorem.

What do you mean by output voltage swing, Q. What do you mean by Output Vol...

Q. What do you mean by Output Voltage Swing? Ideally this is equal to the difference between the two supply rail voltages, although in practice it is a few volts less.

Why are waveguides not used at low frequencies, Q. Comment brie?y on the fo...

Q. Comment brie?y on the following: (a) Why are waveguides not used at low frequencies? (b) Why are open-wire lines not generally used as guiding structures at very high freq

Explain factors affecting permeability and hysterisis loss, Explain the fac...

Explain the factors affecting permeability and hysterisis loss. Factors affecting permeability and hysterisis loss: When the initial permeability is high, the hysterisis los

Explain the tap changing transformers, Explain the Tap Changing Transformer...

Explain the Tap Changing Transformers? This is the most popular form of voltage control at all voltage levels. It is based on changing the turns ratio of the transformer, hence

Fm broadcast system with standard emphasis, Q. A voice message with W f = ...

Q. A voice message with W f = 2π(3×10 3 ) rad/s and Wrms = 2π(1 × 10 3 ) rad/s is transmitted over an FM broadcast system with standard emphasis. and compare the improvements due

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd