Safety in tig welding-radiation energy hazard, Mechanical Engineering

SAFETY IN TIG WELDING-Radiation Energy Hazard

Radiant energy may cause injury to the welder in two areas, eye and the skin. Any personnel, whether the welder, inspection personnel or the helper, present within the immediate vicinity of a welding operation, should be adequately protected from the radiation, particularly the ultraviolet radiation produced by the welding arc. Generally the highest ultraviolet radiant energy intensities are produced when argon shielding gas is used and when aluminium or stainless steel is welded. For the protection of the eye, filter glasses of proper shade depending on the welding current should be used.

The recommended shades for different welding current as prescribed in national / international relevant safety standards and codes should be selected.

Posted Date: 9/17/2012 12:34:45 AM | Location : United States







Related Discussions:- Safety in tig welding-radiation energy hazard, Assignment Help, Ask Question on Safety in tig welding-radiation energy hazard, Get Answer, Expert's Help, Safety in tig welding-radiation energy hazard Discussions

Write discussion on Safety in tig welding-radiation energy hazard
Your posts are moderated
Related Questions
Is bleed necessary in condensing and back pressure both the turbine? What is the use of bleed in steam turbine? What is the basic difference in condensing and backpressure turb

Q. Resource Management for project? An important factor in overall project success is the provision of suitable and adequate resources. The initial estimate of engineering man

Ask question #MiThe steam that leaves the super-heater is expanded from 130bar at 535°C to 25.2bar at 310°C in a high pressure turbine. The steam from the exit of the HP turbine is

function of helium shielding gas

Q. Plant layout and equipment spacing? Layout refers to the location of plants (and process/power units within the plants and associated utilities (or balance of plant)) as wel

Explain Milling Fixture? A milling fixture is a work holding device which is firmly clamped to the table of milling machine. It holds the work piece in correct position as

Effect of Individual Alloying Elements: Sulfur Sulfur is not a needed element in steel since in interferes along with hot rolling and forging resulting in hot-shortness

An experiment to determine the convection coefficient associated with airflow over the surface of a thick stainless steel casting involves insertion of thermocouples in the casting

please help me to calculate the diameter of a brake drum for using in a "brake drum dynamometer engine test rig" the engine specs are as follows: - 6Hp single cylinder 4stroke engi

Results for the Underlying Problem The rules mentioned above and several variants of these rules that became out to be inferior are tested for eight various conditions of the