material , Mechanical Engineering

how r u
Posted Date: 4/12/2013 10:09:24 AM | Location : United Kingdom







Related Discussions:- material , Assignment Help, Ask Question on material , Get Answer, Expert's Help, material Discussions

Write discussion on material
Your posts are moderated
Related Questions
Determine net work done: 5 m 3   of air at 2bar, 27 0 C is compressed to 6bar pressure following PV 1. 3   = constant. It is expanded subsequently adiabaticall

Scalar and Vector quantities: A quantity is a scalar if it is completely defined by its magnitude alone. For example: Length, area, and time. While quantity is said to be vect

Advantages of Pinion Cutter Generating Process 1. A single cutter can be used for cutting all spur gears of identical pitch as that of the cutter. 2. Internal gears can be g

in orthographic projection why in quadrant is taken in anticlock wise

Discuss any three of the following:- (i) Electron Beam Welding (ii) Friction Welding (iii) Thermit Welding (iv) Gas Welding Give their advantages, Limitations, and a

What is Hopper unit Two hydraulically operated folding type hoppers are provided on the front side of the machine. The capacity of the hopper is 4.25 CM.

Determine the axial extension along a load: An open coiled helical spring is created having 10 turns of a mean radius of 60 mm. The wire diameter is 10 mm and coils make an an

Water flows into the sink shown in figure 5 at a flow rate of 8 L/min. If the drain is closed, the water will eventually flow through the overflow drain holes rather than over the